IEC 60034-11-2020 PDF

IEC 60034-11-2020 PDF

Rotating electrical machines-Part 11: Thermal protection

$50.44 $100.88 -50%
Product Code: IEC 60034-11
Stock In Stock
Edition: 3.0
Published: 10/2020
Number of Pages: 30
File Size: 1 file, 1 Byte

Available Options

Product Description

Rotating electrical machines – Part 11: Thermal protection

Introduction: Thermal protection systems are based on the principle of protecting or monitoring the vulnerable machine parts against excessive temperatures. This requires the selection of the appropriate thermal protection device to suit both the type of protection required and the machine component to be protected. This document does not detail the protection methods available or specify the protection method to be used for particular applications, but instead it specifies the temperature of the protected parts that should not be exceeded if a fault or machine abuse occurs. The requirements are not intended to guarantee a "normal" machine life for all conditions of use, but rather to avoid both failure and accelerated premature thermal ageing of the winding insulation. The requirements result from a compromise, since the level of protection should neither be set so low that it causes nuisance tripping nor so high that it allows continuous working at temperatures that will seriously affect the life of the winding insulation. Normal insulation life can only be ensured by correct motor application and maintenance. Frequent operation at above the normal temperature limits, see IEC 60034-1, which cannot be prevented by built-in thermal protection without risking nuisance tripping may lead to a noticeable reduction in machine life. The life of the winding insulation is approximately halved for every 8 K to 10 K increase in the continuous operating temperature. The requirement to incorporate the

Scope: This part of IEC 60034 specifies requirements relating to the use of thermal protectors and thermal detectors incorporated into the stator windings or placed in other suitable positions in induction machines in order to protect them against serious damage due to thermal overloads. It applies to single-speed three-phase 50 Hz or 60 Hz cage induction motors in accordance with IEC 60034-1 and IEC 60034-12 that: have a rated voltage up to 1 000 V; are intended for direct-on-line or star-delta starting. Not included are: direct protection of the rotor winding; the methods of protection only protect rotor windings indirectly; for large motors (particularly 2 pole motors) and for motors starting large inertia loads, special attention is given to rotor heating both when starting and especially after a "trip" has occurred; the protection of bearings and other mechanical parts; the protection methods to be used for particular applications. NOTE 1 Although temperature values given in this document are higher than those specified in IEC 60034-1, they are not in conflict. NOTE 2 Additional requirements may apply to particular motor types, such as those used in household appliances, or for motors used in explosive atmospheres.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 60034-11-2020 PDF

IEC 60034-11-2020 PDF

$50.44 $100.88