IEC 60034-14 CMV-2026 PDF

IEC 60034-14 CMV-2026 PDF

Rotating electrical machines - Part 14: Mechanical vibration of certain machines with shaft heights 56 mm and higher - Measurement, evaluation and limits of vibration severity (Commented Version)

$145.02 $290.03 -50%
Product Code: IEC 60034-14 CMV
Stock In Stock
Edition: 5.0
Published: 11/2026
Number of Pages: 42
File Size: 1 file, 1.6 MB

Available Options

Product Description

Rotating electrical machines - Part 14: Mechanical vibration of certain machines with shaft heights 56 mm and higher - Measurement, evaluation and limits of vibration severity (Commented Version)

Scope: This part of IEC 60034 specifies the factory acceptance vibration test procedures and vibration limits for certain electrical machines under specified conditions, when uncoupled from any load or prime mover. It is applicable to DC and three-phase AC machines, with shaft heights 56 mm and higher and a rated output up to 50 MW, at operational speeds from 120 min–1 up to and including 15 000 min–1. This document is not applicable to machines mounted in situ (on site), three-phase commutator motors, single-phase machines, three-phase machines operated on single-phase systems, vertical waterpower generators, turbine generators greater than 20 MW and machines with magnetic bearings or series-wound machines. NOTE 1 For machines measured in situ, refer to applicable clauses or subclauses of ISO 20816, ISO 10816 and ISO 7919 ISO 20816-1 and ISO 20816-3. NOTE 2 For output power above 50 MW reference is made to the ISO 20816 series. NOTE 3 Vibration routine tests are not mandatory according to IEC 60034-1. If performed, the method for testing is included in this document.

Contents:

  • FOREWORD
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 60034-14 CMV-2026 PDF

IEC 60034-14 CMV-2026 PDF

$145.02 $290.03