IEC 60034-2A-1974 PDF

IEC 60034-2A-1974 PDF

Rotating electrical machines Part 2: Methods for determining losses and efficiency of rotating electrical machinery from tests (excluding machines for traction vehicles) Measurement of losses by the calorimetric method

$72.51 $145.02 -50%
Product Code: IEC 60034-2A
Stock In Stock
Edition: 1.0
Published: 1974
Number of Pages: 40
File Size: 1 file, 2 Bytes

Available Options

Product Description

Rotating electrical machines Part 2: Methods for determining losses and efficiency of rotating electrical machinery from tests (excluding machines for traction vehicles) Measurement of losses by the calorimetric method

Introduction: The calorimetric method can be used to determine the efficiency of electrical rotating machinery: — either by the determination of the total losses on load, — or by the determination of the segregated losses and hence the conventional total loss by summation of the segregated losses. Depending upon the circumstances, calorimetric measurements may be made in two different ways: — either by measuring the quantity and rise in temperature of the cooling medium (direct method), — or by calibration of the rise in temperature of the cooling medium. The calorimetric measurements should be performed for each cooling circuit, either primary or secondary, separately. The methods of loss determination given in this recommendation have been devised mainly for large generators, but the principles used can also be applied to other machines. Page 9 3.1 List of symbols Complete the existing list of symbols by the following: P; = losses inside reference surface Pe = losses outside reference surface P1 = losses which are dissipated by the cooling circuits in the form of heat and which can be measured calori- metrically P2 = losses not transmitted to the cooling medium but which are dissipated through the reference surface by con- duction, convection, radiation, leakage, etc. cp = specific heat capacity of the cooling medium O = volume rate of flow of the cooling medium = density of the cooling medium At = rise in temperature of the cooling medium or temperature difference between the machine re

Contents:

  • FOREWORD
  • INTRODUCTION
  • 3.1 List of symbols

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 60034-2A-1974 PDF

IEC 60034-2A-1974 PDF

$72.51 $145.02