Environmental testing – Part 2-55: Tests – Test Ee and guidance – Loose cargo testing including bounce
Introduction: This test is applicable to specimens which, during transportation on the load-carrying platform of wheeled vehicles either not fastened down or with some degree of freedom, may be subjected to dynamic stresses resulting from random shock conditions (bounce). The test may also be used as a simple means of assessing the satisfactory design of a specimen so far as its structural integrity is concerned. NOTE In practice, this test is primarily applicable to equipment-type specimens and packages. Although the test is performed using a vibrating platform, it is not considered as a vibration test, but as an impact test. Vibration tests should be conducted according to the appropriate standards from IEC 60068-2. In Clause 11, specification writers will find a list of details to be considered for inclusion in specifications and, in Annex A, the necessary accompanying guidance.
Scope: This part of IEC 60068 provides a standard procedure for determining the ability of a specimen to withstand specified severities of bounce, e. g. when transported as loose cargo on wheeled vehicles. This test is primarily intended for specimens prepared for transportation, including specimens in their transport case when the latter may be considered as part of the specimen itself or packages. This test should not be used as a low-frequency vibration test. Although primarily intended for electrotechnical products, this standard is not restricted to them and may be used in other fields where desired.
Contents:
- FOREWORD
- INTRODUCTION
- Scope
- 10 Final measurements
- 11 Information to be given in the relevant specification
- 12 Information to be given in the test report