IEC 60068-2-61-1991 PDF

IEC 60068-2-61-1991 PDF

Environmental Testing Part 2: Test Methods Test Z/ABDM: Climatic Sequence

$72.51 $145.02 -50%
Product Code: IEC 60068-2-61
Stock In Stock
Edition: 1.0
Published: 06/1991
Number of Pages: 33
File Size: 1 file, 1 Byte

Available Options

Product Description

Environmental Testing Part 2: Test Methods Test Z/ABDM: Climatic Sequence

Introduction: The value of a sequence of climatic tests, particularly for the testing of components, has been witnessed by the inclusion of a "climatic sequence" in IEC 68-1 (see clause 7 with guidance in annex B). With the increasing importance of the IEC Quality Assessment System for Electronic Com- ponents (IECQ) it has become necessary to define the test sequence more precisely than could be done in clause 7 of IEC 68-1 with the object of providing for satisfactory reproducibility of the test. This International Standard describes in detail a composite test specifying a "climatic sequence" for specimens of products, primarily components, that is based on clause 7 of IEC 68-1, and it includes guidance in informative annexes for specification writers and those performing the test. NOTE - Test Z/ABDM is a "composite test" as defined in IEC 68-1 rather than a "sequence" as defined in the same standard. Because of the well -established use of "sequence" in references to clause 7 of IEC 68-1 it has been decided that "sequence" should continue to be used in referring to the operations in this composite test.

Scope: This International Standard provides standard composite test methods for determining the suitability of a specimen when subjected to environmental conditions consisting of a sequence of temperature, humidity and, where required, low air pressure environmental stresses. The order of application of the stresses and conditions for the change from one step to the next have been chosen to accelerate and amplify degradation mechanisms of the same type as those observed under natural climatic conditions. NOTE – Environmental conditions occurring in nature are classified in IEC 721-2 and IEC 721-3. This standard may be applied to other electrotechnical products when the degradation me- chanisms are the same and the specified requirements for testing can be satisfied. In other cases, it may form a basis for the writing of a similar test. In this test, specimens are exposed to environmental tests in a standard order and categorized according to the basic code defined in Appendix A of IEC 68-1 except that the third group of digits is used as an indication of the number of cycles in Step 5 of the damp heat cyclic Test Db according to clause 6 in IEC 68-2-30. In the climatic categories -/-/56, 40/-/-, etc., in this standard the dashes may be replaced by any of the standard values appropriate to the space as in the following examples: 55/100/56, 25/085/56, 40/085/21. Where any modification is necessary, the relevant specification shall provide the necessary information for each step in the selected method (see clause 8). This test is frequently specified to follow other tests involving mechanical stress, for example tests for robustness of terminations, solderability, shock and vibration, as a means of determining whether the sealing of the specimen has been damaged.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 60068-2-61-1991 PDF

IEC 60068-2-61-1991 PDF

$72.51 $145.02