IEC 60068-2-65-2013 PDF

IEC 60068-2-65-2013 PDF

Environmental testing-Part 2-65: Tests-Test Fg: Vibration-Acoustically induced method

$163.93 $327.86 -50%
Product Code: IEC 60068-2-65
Stock In Stock
Edition: 2.0
Published: 02/2013
Number of Pages: 66
File Size: 1 file, 422 Bytes

Available Options

Product Description

Environmental testing – Part 2-65: Tests – Test Fg: Vibration – Acoustically induced method

Introduction: Acoustic noise may produce significant vibration in components and equipment. In the acoustic noise field, sound pressure fluctuations impinge directly on the specimen and the response may be different to that produced by mechanical excitation. Items particularly sensitive to acoustic noise include relatively lightweight items whose dimensions are comparable to an acoustic wavelength in the frequency range of interest and whose mass per unit area is low, such as dish antennas and solar panels, electronic devices, printed circuit boards, optical elements, etc. Acoustic testing is applicable to components, equipment, functional units and other products, hereinafter referred to as “specimens”, which are liable to be exposed to and/or are required to function in conditions of high sound pressure levels. It should be noted that, under service conditions, the specimen may be subjected to simultaneous mechanical and acoustical excitation. High sound pressure levels may be generated by jet engines and other aircraft propulsion systems, rocket motors, high-powered gas circulators, turbulent gas flow around aircraft or launchers, etc. This part of IEC 60068 deals with acoustic testing in compressible gases and can also be used to simulate the excitation response caused by turbulence resulting from high- velocity separated gas flows. The intent of the test procedure contained in this standard is to produce a high intensity acoustic noise field by either reverberant methods (known as rev

Scope: This part of IEC 60068 provides standard procedures and guidance for conducting acoustic tests in order to determine the ability of a specimen to withstand vibration caused by a specified sound-pressure level environment to which it is, or is liable to be, subjected. For sound pressure level environments of less than 120 dB acoustic tests are not normally required. This standard determines the mechanical weakness and/or degradation in the performance of specimens and to use this information, in conjunction with the relevant specification, to decide on their acceptability for use. The methods of test may also be used as a means of establishing the mechanical robustness or fatigue resistance of specimens. Two procedures are described for conducting tests and for measurement of the sound pressure levels within the acoustic noise field and considers the need for measurement of the vibration responses at specified points on the specimen. It also gives guidance for the selection of the acoustic noise environment, spectrum, sound pressure level and duration of exposure. The progressive wave tube method is relevant to material where aerodynamic turbulence will excite part, or all, of the total external surface. Such applications include aircraft panel assemblies where the excitation exists on one side only. The reverberant chamber method is relevant where it is preferable to induce vibration onto the entire external surface of equipment by distributed excitation rather than fixed points by means of electro-dynamic shakers.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope
  • 10 Recovery
  • 11 Final measurements
  • 12 Information to be given in the relevant specification
  • 13 Information to be given in the test report

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 60068-2-65-2013 PDF

IEC 60068-2-65-2013 PDF

$163.93 $327.86