Environmental Testing - Part 2: Test Methods - Test Cx: Damp Heat, Steady State (Unsaturated Pressurized Vapour)
Scope: This International Standard provides a standard test procedure for the purpose of evaluating, in an accelerated manner, the resistance of small electrotechnical products, primarily non- hermetically sealed components, to the deteriorative effect of damp heat. The test is not intended to evaluate external effects, such as corrosion and deformation. 2 General description In this test, the specimen is subjected to very high levels of unsaturated damp heat for a relatively short period. Electrical bias is usually applied. Due to the very accelerated nature of the test, careful consideration must be given to the choice of test conditions, since this may have an impo rtant effect on the type of failure mode which could occur (see annex B). The test provides three temperatures at a relative humidity of 85 %. The test severity is defined by the duration at one of the temperatures. Care shall be taken not to reach the maximum rated temperature of the specimen and/or the critical temperature of any encapsulating materials. The glass transition temperature of a plastic is a typical example of a critical transition temperature. In the case of plastic encapsulated components, degradation results from absorption of water-vapour by the plastic, and penetration of moisture along terminals. 3 Description of test apparatus 3.1 The test chamber The chamber shall be so constructed that: a) it can produce the temperature and relative humidity given in table 1, and sustain the pressure values given in clause 4, note 3; b) it is capable of providing controlled conditions of temperature, relative humidity and pressure during testing, and the ramp-up to, and ramp-down from, specified test conditions; c) the temperature and humidity of the chamber can be monitored by means of sens- ing devices located in the working space, and/or other areas giving the same results (e.g. a steam generator). NOTE - The direct measurement of relative humidity during this test is not possible with current techniques. Guidance on the determination of the relative humidity in the working space is given in annex C.
Contents:
- FOREWORD
- 1 Scope
- 2 General description
- 3 Description of test apparatus
- 4 Severities
- 5 Initial measurements
- 6 Testing
- 7 Intermediate measurements
- 8 Recovery
- 9 Final measurements
- 10 Information to be given in the relevant specification