IEC 60068-2-67-2019 PDF

IEC 60068-2-67-2019 PDF

Environmental testing-Part 2-67: Tests-Test Cy: Damp heat, steady state, accelerated test primarily intended for components

$53.59 $107.18 -50%
Product Code: IEC 60068-2-67
Stock In Stock
Edition: 1.1
Published: 07/2019
Number of Pages: 46
File Size: 1 file, 1 Byte

Available Options

Product Description

Environmental testing – Part 2-67: Tests – Test Cy: Damp heat, steady state, accelerated test primarily intended for components

Scope: This International Standard provides a standard test procedure for the purpose of evaluating, in an accelerated manner, the resistance of small electrotechnical products, primarily non hermetically sealed components, to the deteriorative effect of damp heat. The test is not intended to evaluate external effects such as corrosion and deformation. General description In this test the specimen is subjected to very high levels of unsaturated damp heat for a relatively long period. Electrical bias is usually applied. The test provides a number of preferred durations at a relative humidity of 85 % and a temperature of 85 °C. In the case of plastic encapsulated components degradation results from absorption of water- vapour by the plastic and penetration of moisture along terminals. Description of test apparatus 3.1 The test chamber The chamber shall be so constructed that: a) it can produce the temperature and relative humidity given in table 1 for a minimum period of 2 000 h without interruption; b) it is capable of providing controlled conditions of temperature and relative humidity during testing, and the ramp-up to and ramp-down from specified test conditions; c) the temperature and humidity of the chamber can be monitored by means of sensing devices located in the working space and/or other areas giving the same results; d) any water shall be continuously drained from the working space and not re-used; e) condensed water is not allowed to fall on the specimen; f) the materials used in the construction shall not cause any significant corrosion of the specimen, or degradation of the quality of the humidifying water (see clause B.1). The temperature tolerance of ±2 °C is intended to take account of absolute errors in the measurement, fluctuations of the chamber temperature at any point and variations between any two points within the working space. However, in order to maintain the relative humidity within the specified tolerance of ±5 %, it is necessary to keep the difference between any two points in the working space (at any instant) within narrower limits. – 12 – IEC 60068-2-67:1995+AMD1:2019 CSV © IEC 2019 AVANT-PROPOS ..........................................

Contents:

  • FOREWORD
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 60068-2-67-2019 PDF

IEC 60068-2-67-2019 PDF

$53.59 $107.18