Environmental testing - Part 2-75: Tests - Test Eh: Hammer tests
Introduction: Mechanical impacts likely to stress electrotechnical equipment in service can be generated by hammers of various types. For standardization purposes, the results of such testing should not depend on the type of testing apparatus and therefore, the characteristics of the various types of test hammers described in this part of IEC 60068 are intended to be as close as practicable for the same severity level. It is important to note that both Clause 3 and the test method selected from Clauses 4, 5, and 6 need to be complied with in order to satisfy the requirements of this International Standard. The severity levels are, in general, taken from IEC 60721-1. For coordination purposes, it has been necessary to change certain fundamental parameters of the previous tests Ef: Impact, pendulum hammer, and Eg: Impact, spring hammer. In all cases, both sets of parameters are shown at the appropriate places in the text. Although some values are no longer recommended, they have been retained as alternatives for historical consistency purposes. This is because they have application in certain industries as historic comparators.
Scope: This part of IEC 60068 provides three standardized and coordinated test methods for determining the ability of a specimen to withstand specified severities of impact. It is used, in particular, to demonstrate an acceptable level of robustness when assessing the safety of a product and is primarily intended for the testing of electrotechnical items. It consists of the application to the specimen of a prescribed number of impacts defined by their impact energy and applied in the prescribed directions. This part of IEC 60068 covers energy levels ranging from 0,14 J (joules) to 50 J (joules). Three types of test apparatus are applicable to perform these tests. Annex C provides some guidance as to this aspect.
Contents:
- FOREWORD
- INTRODUCTION
- Scope