Environmental testing – Part 2-88: Tests – Test XD: Resistance of components and assemblies to liquid cleaning media
Introduction: a) Background Current manufacturing processes preferably do not use cleaning steps for the sake of cost saving, environmental impacts, and potentially detrimental effects to quality and reliability of the equipment. But there are situations, where cleaning of components or assemblies becomes unavoidable, for example when it is necessary to apply protective coatings, or cleaning is required by specific regulations concerning the end use of the equipment. It is the challenge for process engineers to select effective cleaning media and processes at one side, and on the other side to evaluate whether the components and circuit boards exposed to those processes can withstand it without being damaged or their performance being deteriorated. b) Current industry standard test methods Current standards, like IEC 60068-2-45 [1]1 and some other component standards describe resistance to solvents tests, but the test liquids used for testing (e.g. alcohols) are not commonly used in real industrial cleaning processes. In addition, the current resistance to solvent test methods are immersion tests without any mechanical load to the components or ultrasonic agitation. The current focus of these tests is mainly on the legibility of marking, etc. Other standards, like MIL-STD-202 [12], Method 215K, describe very specific qualification processes and solvents, which again are not common in today’s manufacturing processes of electronic equipment. c) To close the gap It is the intention of this do
Scope: This part of IEC 60068-2 establishes test methods for the resistance of electronic and electromechanical components, unpopulated circuit boards and assemblies to liquid cleaning media and cleaning processes, which are agreed between user and supplier for applications, where cleaning is required. These tests are not applicable to components, unpopulated circuit boards and assemblies, which are not intended to be subjected to cleaning processes. Tests XD1 and XD2 primarily are intended for qualification testing of components and unpopulated circuit boards suitable for cleaning processes but can be adopted as well to testing of material compatibility and specific cleaning media used in manufacturing processes of components and unpopulated circuit boards. Test XD3 is intended to determine the resistance of electronic assemblies suitable for cleaning processes to the various cleaning processes to which they are exposed during manufacturing, including the effects of assembly and soldering processes.
Contents:
- FOREWORD
- INTRODUCTION
- Scope