Electrical installations in ships - Part 302-2: Low voltage switchgear and controlgear assemblies - Marine power
Introduction: This part of IEC 60092 forms a series of International Standards for electrical installations in sea-going ships, incorporating good practice and coordinating, as far as possible, existing rules. These standards form a code of practical interpretation and amplification of the requirements of the International Convention for the Safety of Life at Sea, a guide for future regulations which may can be prepared and a statement of practice for use by ship owners, shipbuilders and appropriate organizations. The IEC 61439 series identifies specifies the requirements for land based low voltage switchgear and controlgear assemblies. The IEC 60092-302 series has been developed in line with Figure 201, which shows the future intention to develop appropriate marine standards for final distribution boards to be operated by ordinary persons; and busbar trunking systems illustrates opportunities to develop relevant marine standards. The IEC 60092 series remains the principal series of standards for electrical installations in ships, and the applicable standards are applied accordingly. Wherever there are differences between the IEC 61439 series and the IEC 60092 series, the IEC 60092 series takes precedence. Key Under consideration. NOTE At the time of publication, IEC 60092-302-3 and IEC 60092-302-6 are not developed. The figure shows that these standards are potential future projects to align with the IEC 61439 series. IEC IEC 61439-1 IEC 60092 IEC 61439-2 IEC 61439-3 IEC 61439-4 IEC 61439
Scope: This part of IEC 60092 defines the specific requirements of low voltage marine power switchgear and controlgear assemblies (MPSC-assemblies) as follows: stationary assemblies with enclosure for which the rated voltage does not exceed 1 000 V AC or 1500 V DC; assemblies intended for use in conjunction with the power generation, distribution and conversion of electric energy, and for the control of electric energy consuming equipment. Due to the marine application and the risks associated with loss of power, additional safety factors have been applied to minimise the risk of failure, such as applying an additional safety factor on clearance distances. This document applies to all assemblies whether they are designed, manufactured and verified on a one-off basis or fully standardised and manufactured in quantity. Either the manufacture and/or assembly, or both, of the MPSC assembly can be carried out by others than by the original manufacturer. This document does not apply to individual devices and self-contained components, such as motor starters, fuse switches, electronic equipment, which comply with the relevant product standards. NOTE Individual devices and components include those that are covered by the IEC 60947 series.
Contents:
- FOREWORD
- INTRODUCTION
- Scope