IEC 60115-6-2-1983 PDF

IEC 60115-6-2-1983 PDF

Fixed Resistors for Use in Electronic Equipment Part 6: Blank Detail Specification - Fixed Resistor Networks with Individually Measurable Resistors, of Either Different Resistance Values or Different Rated Dissipations Assessment Level E

$25.22 $50.44 -50%
Product Code: IEC 60115-6-2
Stock In Stock
Edition: 1.0
Published: 01/1983
Number of Pages: 24
File Size: 1 file, 811 Bytes

Available Options

Product Description

Fixed Resistors for Use in Electronic Equipment Part 6: Blank Detail Specification - Fixed Resistor Networks with Individually Measurable Resistors, of Either Different Resistance Values or Different Rated Dissipations Assessment Level E

Introduction: Blank detail specification A blank detail specification is a supplementary document to the Sectional Specification and contains requirements for style and layout and minimum content of detail specifications. Detail specifications not complying with these requirements shall not be considered as being in accord- ance with I E C specifications nor shall they so be described. In the preparation of detail specifications the content of Sub-clause 1.4 of the Sectional Specification shall be taken into account. The numbers between brackets on the first page correspond to the following information which shall be inserted in the position indicated : Identification of the detail specification [1] The "International Electrotechnical Commission" or the National Standards Organization under whose authority the detail specification is drafted. [2] The I E C or National Standards number of the detail specification, date of issue and any further information required by the national system. [3] The number and issue number of the I E C or national Generic Specification. [4] The I E C number of the blank detail specification. Identification of the resistor network [5] A short description of the type of resistor network. [6] Electrical circuit showing all resistors and connections contained in the network. Terminal pin numbers shall be shown. Alternatively, this drawing may be given in an appendix to the detail specification. [7] Information on typical construction (when applicable). Note. — When

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 60115-6-2-1983 PDF

IEC 60115-6-2-1983 PDF

$25.22 $50.44