IEC 60127-9-2025 PDF

IEC 60127-9-2025 PDF

Miniature fuses - Part 9: Miniature fuse-links for special applications with partial-range breaking capacity

$163.93 $327.86 -50%
Product Code: IEC 60127-9
Stock In Stock
Edition: 1.0
Published: 08/2025
Number of Pages: 70
File Size: 1 file, 1 Byte

Available Options

Product Description

Miniature fuses - Part 9: Miniature fuse-links for special applications with partial-range breaking capacity

Introduction: According to the wish expressed by the users of miniature fuses, all standards, recommendations and other documents relating to miniature fuses have the same publication number in order to facilitate reference to fuses in other specifications, for example, equipment specifications. Furthermore, a single publication number and subdivision into parts would facilitate the establishment of new standards, because clauses containing general requirements need not be repeated. The IEC 60127 series, under the general heading Miniature fuses, is thus subdivided as follows: IEC 60127-1, Miniature fuses - Part 1: Definitions for miniature fuses and general requirements for miniature fuse-links IEC 60127-2, Miniature fuses - Part 2: Cartridge fuse-links IEC 60127-3, Miniature fuses - Part 3: Sub-miniature fuse-links IEC 60127-4, Miniature fuses - Part 4: Universal modular fuse-links (UMF) - Through-hole and surface mount types IEC 60127-5, Miniature fuses - Part 5: Guidelines for quality assessment of miniature fuse-links IEC 60127-6, Miniature fuses - Part 6: Fuse-holders for miniature fuse-links IEC 60127-7, Miniature fuses - Part 7: Miniature fuse-links for special applications IEC 60127-8, Miniature fuses - Part 8: Fuse resistors with particular overcurrent protection IEC 60127-9, Miniature fuses - Part 9: Miniature fuse-links for special applications with partial- range breaking capacity

Scope: This part of IEC 60127 covers requirements for miniature fuse-links for special applications with partial-range breaking capacity. This document is applicable to fuse-links with a rated voltage not exceeding 1 000 V, a rated current not exceeding 150 A and a rated breaking capacity not exceeding 50 kA. Miniature fuse-links with partial-range breaking capacity are used only to operate under short circuit conditions. They cannot be applied under overload conditions. The design engineer needs to ensure no overload conditions can be seen by the fuse approved under this document. This document does not apply to fuses completely covered by IEC 60127-7 or the subsequent parts of IEC 60269-1. It does not apply to miniature fuse-links for appliances intended to be used under special conditions, such as in corrosive or explosive atmospheres. This part of IEC 60127 applies in addition to the requirements of IEC 60127-1. Miniature fuse-links for special applications with partial-range breaking capacity are not intended to be replaced by the end-user of an electrical / electronic appliance. The object of this document is to establish uniform test methods for miniature fuse-links for special applications with partial-range breaking capacity, so as to allow verification of the values (for example melting time and breaking capacity values) specified by the manufacturer.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope
  • 101 Standard sheets
  • 101.1 Standard sheet 1 – Fuse-links for special applications

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 60127-9-2025 PDF

IEC 60127-9-2025 PDF

$163.93 $327.86