Radio-frequency connectors Part 13: R.F. coaxial connectors with inner diameter of outer conductor 5,6 mm (0,22 in) – Characteristic impedance 75 ohms (Type 1.6/5.6) – Characteristic impedance 50 ohms (Type 1.8/5.6) with similar mating dimensions
Introduction: The different mounting and service conditions, even in one electronic unit, require, to a large extent, coaxial connectors the locking mechanisms of which meet these requirements, as for example connectors with thread or snap-on or push-pull devices or connectors which are suitable for slide-in rack and panel applications. It is of particular advantage if these connectors, irrespective of their different locking systems, may be plugged together, for instance, for ease of measuring. The connectors dealt with in this publication offer these facilities by having a uniform contact system and suitable design of the locking device. The two types of connectors 75 E2 and 50 E2 have the same mating face and it is possible to connect the 1.6/5.6 type with the 1.8/5.6 type without damaging the connectors. The type designation 1.6/5.6 and 1.8/5.6 under which these connectors are already known according to different national standards refers with Figure 1, page 10, to the nominal effective outer diameter of the inner conductor of the connector and with Figure 2, page 11, to the effective inner diameter of the outer conductor. 1. Scope This standard concerns patterns of prefered types of r.f. coaxial connectors which may preferably be used in the 75 u range with cables 96 IEC 75-4-1 and 96 IEC 75-4-2 and in the 50 S2 range with cables 96 IEC 50-2-2 and 96 IEC 50-3-1 of IEC Publication 96-2, Radio-frequency Cables, Part 2: Relevant cable specifications. This specification refers to solder t
Contents:
- FOREWORD
- INTRODUCTION
- Scope