Safety of machinery - Electrical equipment of machines - Part 1: General requirements
Introduction: This part of IEC 60204 provides requirements and recommendations relating to the electrical equipment of machines so as to promote: safety of persons and property; consistency of control response; ease of operation and maintenance. More guidance on the use of this part of IEC 60204 is given in Annex F. Figure 1 has been provided as an aid to the understanding of the inter-relationship of the various elements of a machine and its associated equipment. Figure 1 is a block diagram of a typical machine and associated equipment showing the various elements of the electrical equipment addressed in this part of IEC 60204. Numbers in parentheses ( ) refer to Clauses and Subclauses in this part of IEC 60204. It is understood in Figure 1 that all of the elements taken together including the safeguards, tooling/fixturing, software, and the documentation, constitute the machine, and that one or more machines working together with usually at least one level of supervisory control constitute a manufacturing cell or system.
Scope: This part of IEC 60204 applies to the application of electrical, electronic and programmable electronic equipment and systems to machines not portable by hand while working, including a group of machines working together in a co-ordinated manner. NOTE 1 This part of IEC 60204 is an application standard and is not intended to limit or inhibit technological advancement. NOTE 2 In this part of IEC 60204, the term “electrical” includes electrical, electronic and programmable electronic matters (i.e. “electrical equipment” means electrical, electronic and programmable electronic equipment). NOTE 3 In the context of this part of IEC 60204, the term “person” refers to any individual and includes those persons who are assigned and instructed by the user or his agent(s) in the use and care of the machine in question. The equipment covered by this part of IEC 60204 commences at the point of connection of the supply to the electrical equipment of the machine (see 5.1). NOTE 4 The requirements for the electrical supply installation in buildings are given in the IEC 60364 series. This part of IEC 60204 is applicable to the electrical equipment or parts of the electrical equipment that operate with nominal supply voltages not exceeding 1 000 V for alternating current (AC) and not exceeding 1 500 V for direct current (DC), and with nominal supply frequencies not exceeding 200 Hz. NOTE 5 For higher voltages, see Information on electrical equipment or parts of the electrical equipment that operate with higher nominal supply voltages can be found in IEC 60204-11. This part of IEC 60204 does not cover all the requirements (for example guarding, interlocking, or control) that are needed or required by other standards or regulations in order to protect persons from hazards other than electrical hazards. Each type of machine has unique requirements to be accommodated to provide adequate safety. This part of IEC 60204 specifically includes, but is not limited to, the electrical equipment of machines as defined in 3.1.40. NOTE 6 Annex C lists examples of machines whose electrical equipment can be covered by this part of IEC 60204. This part of IEC 60204 does not specify additional and
Contents:
- FOREWORD
- INTRODUCTION
- Scope