Guide for the determination of thermal endurance properties of electrical insulating materials - Part 1: General procedures for the determination of thermal endurance properties, temperature indices and thermal endurance profiles
Introduction: The listing of the thermal capabilities of electrical insulating materials, based on service experience, was found to be impractical, owing to the rapid development of polymer and insulation technologies and the long time necessary to acquire appropriate service experience. Accelerated ageing and test procedures were therefore needed to obtain the necessary information. The IEC 60216 series [1] has been developed to formalize these procedures and the interpretation of their results. Physico-chemical models postulated for the ageing processes led to the almost universal assumption of the Arrhenius equations to describe the rate of ageing. Out of this arose the concept of the temperature index (TI) as a single-point characteristic based upon accelerated ageing data. This is the numerical value of the temperature in degrees Celsius at which the time taken for deterioration of a selected property to reach an accepted end-point is that specified (usually 20 000 h). NOTE The term Arrhenius is widely used (and understood) to indicate a linear relationship between the logarithm of a time and the reciprocal of the thermodynamic (absolute or kelvin) temperature. The correct usage is restricted to such a relationship between a reaction rate constant and the thermodynamic temperature. The common usage is employed throughout this document. The large statistical scatter of test data which was found, together with the frequent occurrence of substantial deviations from the ideal behaviour, d
Scope: This part of IEC 60216 specifies the general ageing conditions and procedures to be used for deriving thermal endurance characteristics and gives guidance in using the detailed instructions and guidelines in the other parts of IEC 60216. Although originally developed for use with electrical insulating materials and simple combinations of such materials, the procedures are considered to be of more general applicability and are widely used in the assessment of materials not intended for use as electrical insulation. In the application of this document, it is assumed that a practically linear relationship exists between the logarithm of the time required to cause the predetermined property change and the reciprocal of the corresponding absolute temperature (Arrhenius relationship). For the valid application of this document, no transition, in particular no first-order transition, is expected to occur in the temperature range under study.
Contents:
- FOREWORD
- INTRODUCTION
- Scope