IEC 60287-1-3-2023 PDF

IEC 60287-1-3-2023 PDF

Electric cables-Calculation of the current rating-Part 1-3: Current rating equations (100 % load factor) and calculation of losses-Current sharing between parallel single-core cables and calculation of circulating current losses

$100.88 $201.76 -50%
Product Code: IEC 60287-1-3
Stock In Stock
Edition: 2.0
Published: 05/2023
Number of Pages: 26
File Size: 1 file, 765 Bytes

Available Options

Product Description

Electric cables – Calculation of the current rating – Part 1-3: Current rating equations (100 % load factor) and calculation of losses – Current sharing between parallel single-core cables and calculation of circulating current losses

Introduction: When single-core cables are installed in parallel, it is possible that the load current will not share equally between the parallel cables. The circulating currents in the sheaths of the parallel cables will also differ. This is because a significant proportion of the impedance of large conductors is due to self reactance and mutual reactance. Hence the spacing and relative location of each cable will have an effect on the current sharing and the circulating currents. The currents are also affected by phase rotation. The method described in this document can be used to calculate the current sharing between conductors as well as the circulating current losses. There is no simple rule by which the circulating current losses of parallel cables can be estimated. Calculation for each cable configuration should be applied. The principles and impedance formulae involved are straightforward but the difficulty arises in solving the large number of simultaneous equations generated. The number of equations to be solved generally precludes the use of manual calculations and solution by computer is recommended. For nc cables per phase having metallic sheaths in a three-phase system there are 6 · nc equations containing the same number of complex variables. For simplicity the equations set out in this document assume that the parallel conductors all have the same cross-sectional area. If this is not the case, the equations should be adapted to allow for different resistances for each condu

Scope: This part of IEC 60287 provides a method for calculating the phase currents and circulating current losses in single-core cables arranged in parallel. The method described in this document can be used for any number of cables per phase in parallel in any physical layout. The phase currents can be calculated for any arrangement of sheath bonding. For the calculation of sheath losses, it is assumed that the sheaths are bonded at both ends. A method for calculating sheath eddy current losses in two circuits in flat formation is given in IEC 60287-1-2.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 60287-1-3-2023 PDF

IEC 60287-1-3-2023 PDF

$100.88 $201.76