IEC 60296 (REDLINE + STANDARD)-2012 PDF

IEC 60296 (REDLINE + STANDARD)-2012 PDF

Fluids for electrotechnical applications-Unused mineral insulating oils for transformers and switchgear

$171.50 $342.99 -50%
Product Code: IEC 60296 (REDLINE + STANDARD)
Stock In Stock
Edition: 4.0
Published: 02/2012
Number of Pages: 72
File Size: 1 file, 1.2 MB

Available Options

Product Description

Fluids for electrotechnical applications – Unused mineral insulating oils for transformers and switchgear

Introduction: This International Standard does not purport to address all the safety problems associated with its use. It is the responsibility of the user of the standard to establish appropriate health and safety practices and determine the applicability of regulatory limitations prior to use. The mineral insulating oils which are the subject of this standard should be handled with due regard to personal hygiene. Direct contact with the eyes may cause irritation. In the case of eye contact, irrigation with copious quantities of clean running water should be carried out and medical advice sought. Some of the tests specified in this standard involve the use of processes that could lead to a hazardous situation. Attention is drawn to the relevant standard for guidance. This standard is applicable to mineral insulating oils, chemicals and used sample containers. The disposal of these items should be carried out according to local regulations with regard to their impact on the environment. Every precaution should be taken to prevent release of mineral insulating oil into the environment.

Scope: This International Standard is applicable to specifications and test methods for unused mineral insulating oils (see Clause 3 for definitions). It applies to oil delivered to the agreed point and time of delivery, intended for use in transformers, switchgear and similar electrical equipment in which oil is required for insulation and heat transfer. These oils are obtained by refining, modifying and/or blending of petroleum products and other hydrocarbons. Oils with and without additives are both within the scope of this standard. This standard is applicable only to unused mineral insulating oils. Recycled oils are beyond the scope of this standard. NOTE Definitions and specifications for recycled oils will be covered by IEC 627011. This standard does not apply to mineral insulating oils used as impregnants in cables or capacitors.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope
  • 6.10 Corrosive and potentially corrosive sulphur
  • 6.11 Additives (see 3.4)
  • 6.11.1 General
  • 6.11.2 Antioxidant additives (see 3.5)
  • 6.11.3 Metal passivators
  • 6.11.4 Pour point depressants
  • 6.12 Oxidation stability
  • 6.13 Gassing tendency
  • 6.14 Electrostatic charging tendency (ECT)
  • 6.15 Flash point
  • 6.16 Density
  • 6.17 Polycyclic aromatic content (PCAs)
  • 6.18 Polychlorinated biphenyl content (PCBs)
  • 6.19 2-Furfural (2-FAL) and related compounds content
  • 6.20 Particle content

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 60296 (REDLINE + STANDARD)-2012 PDF

IEC 60296 (REDLINE + STANDARD)-2012 PDF

$171.50 $342.99