IEC 60331-12-2002 PDF

IEC 60331-12-2002 PDF

Tests for Electric Cables under Fire Conditions - Circuit Integrity - Part 12: Apparatus - Fire with Shock at a Temperature of at Least 830 Degrees C

$50.44 $100.88 -50%
Product Code: IEC 60331-12
Stock In Stock
Edition: 1.0
Published: 07/2002
Number of Pages: 38
File Size: 1 file, 605 Bytes

Available Options

Product Description

Tests for Electric Cables under Fire Conditions - Circuit Integrity - Part 12: Apparatus - Fire with Shock at a Temperature of at Least 830 Degrees C

Introduction: IEC 60331 consists of the following parts under the general title: Tests for electric cables under fire conditions – Circuit integrity: Part 11: Apparatus – Fire alone at a flame temperature of at least 750 °C Part 12: Apparatus – Fire with shock at a temperature of at least 830 °C NOTE 1 Further parts are under consideration (e.g. for fire with water spray). Part 21: Procedures and requirements – Cables of rated voltage up to and including 0,6/1,0 kV Part 23: Procedures and requirements – Electric data cables Part 25: Procedures and requirements – Optical fibre cables NOTE 2 Parts 21, 23 and 25 relate to fire-only conditions. Part 31: Procedures and requirements for fire with shock – Cables of rated voltage up to and including 0,6/1,0 kV IEC 60331-12 introduces apparatus to allow cables to be tested under conditions of mechanical shock as well as fire. It also introduces a larger flame source, which is especially useful for testing larger diameter cables and which, in conjunction with the mechanical shock, meets an increasing demand for more comprehensive testing of circuit integrity cables. IEC 60331-12 is especially suited for use in conjunction with IEC 60331-31.

Scope: This part of IEC 60331 specifies the test apparatus to be used for testing cables required to maintain circuit integrity when subject to fire and mechanical shock where the test condition is based upon a flame with a controlled heat output corresponding to a temperature of a nominal 850 °C. It is intended for use when testing cables of greater than 20 mm overall diameter. It also provides, in annex A, the method of verification of the burner and control system used for the test.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 60331-12-2002 PDF

IEC 60331-12-2002 PDF

$50.44 $100.88