Household and similar electrical appliances – Safety – Part 2-103: Particular requirements for drives for gates, doors and windows (Commented Version)
Introduction: It has been assumed in the drafting of this International Standard that the execution of its provisions is entrusted to appropriately qualified and experienced persons. Guidance documents concerning the application of the safety requirements for appliances can be accessed via TC 61 supporting documents on the IEC website https://www.iec.ch/tc61/supportingdocuments This information is given for the convenience of users of this International Standard and does not constitute a replacement for the normative text in this standard. This standard recognizes the internationally accepted level of protection against hazards such as electrical, mechanical, thermal, fire and radiation of appliances when operated as in normal use taking into account the manufacturer's instructions. It also covers abnormal situations that can be expected in practice and takes into account the way in which electromagnetic phenomena can affect the safe operation of appliances. This standard takes into account the requirements of IEC 60364 as far as possible so that there is compatibility with the wiring rules when the appliance is connected to the supply mains. However, national wiring rules may can differ. If an appliance within the scope of this standard also incorporates functions that are covered by another part 2 of IEC 60335, the relevant part 2 is applied to each function separately, as far as is reasonable. If applicable, the influence of one function on the other is taken into account. When a part 2
Scope: This clause of Part 1 is replaced by the following. This part of IEC 60335 deals with the safety of electric drives for horizontally and vertically moving gates, doors, garage doors and windows for household and similar purposes, their rated voltage being not more than 250 V for single-phase drives and 600 V for other drives including direct current (DC) supplied appliances and battery-operated appliances 3. It also covers the hazards associated with the movement of the driven part. Battery-operated drives and other d.c. supplied drives are within the scope of this standard. Dual supply drives, either mains-supplied or battery-operated, are regarded as battery- operated drives when operated in the battery mode. Drives not intended for normal household use but which nevertheless may can be a source of danger to the public, such as drives intended to be used by laymen in shops, offices, hotels, restaurants, hospitals, in industry and on farms, are within the scope of this standard. Requirements for drives for doors that may can be used in emergency routes and exits are given in normative Annex AA. NOTE 101 Examples of drives within the scope of this standard are drives for folding doors; revolving doors; rolling doors; roof windows; sectional overhead doors; swinging and sliding gates or doors. NOTE 101 Examples are shown in Figure 101. NOTE 102 Drives may can be supplied with a driven part. As far as is practicable, this standard deals with the common hazards presented by drives that are encountered by all persons in and around the home. However, in general, it does not take into account persons (including children) whose physical, sensory or mental capabilities; or lack of experience and knowledge prevents them from using the drive safely without supervision or instruction; children playing with the drive. NOTE 103 For appliances intended to be used in vehicles or on board ships or aircraft, additional requirements can be necessary. Attention is drawn to the fact that In many countries, additional IEC 60335-2-103:2023 CMV © IEC 2023 – 9 – requirements are specified by the national health authorities, the national authorities responsible for the protection of lab
Contents:
- FOREWORD
- INTRODUCTION
- Scope