Household and similar electrical appliances – Safety – Part 2-108: Particular requirements for electrolysers
Introduction: It has been assumed in the drafting of this International Standard that the execution of its provisions is entrusted to appropriately qualified and experienced persons. Guidance documents concerning the application of the safety requirements for appliances can be accessed via TC 61 supporting documents on the IEC website https://www.iec.ch/tc61/supportingdocuments This information is given for the convenience of users of this International Standard and does not constitute a replacement for the normative text in this standard. This standard recognizes the internationally accepted level of protection against hazards such as electrical, mechanical, thermal, fire and radiation of appliances when operated as in normal use taking into account the manufacturer's instructions. It also covers abnormal situations that can be expected in practice and takes into account the way in which electromagnetic phenomena can affect the safe operation of appliances. This standard takes into account the requirements of IEC 60364 as far as possible so that there is compatibility with the wiring rules when the appliance is connected to the supply mains. However, national wiring rules can differ. If an appliance within the scope of this standard also incorporates functions that are covered by another part 2 of IEC 60335, the relevant part 2 is applied to each function separately, as far as is reasonable. If applicable, the influence of one function on the other is taken into account. When a part 2 sta
Scope: This clause of Part 1 is replaced by the following. This part of IEC 60335 deals with the safety of electrolysers that produce low viscosity, ionized liquids intended for use as detergent free wash water in appliances for household and similar purposes and which conform with the standards applicable to such appliances. It applies to electrolysers tested separately, under the most severe conditions that can be expected to occur in normal use, their rated voltage being not more than 250 V including direct current (DC) supplied appliances and battery-operated appliances. Examples of appliances that can contain electrolysers are dishwashers (IEC 60335-2-5); washing machines (IEC 60335-2-7); appliances producing wash water for hygiene purposes. This standard does not supersede the requirements of standards relevant to the particular appliance in which the electrolyser is used. However, if the electrolyser used complies with this standard, the tests for the electrolyser specified in the particular appliance standard can be unnecessary in the particular appliance or assembly. If the electrolyser control system is associated with the particular appliance control system, additional tests can be necessary on the final appliance. Guidance for additional requirements to be considered for inclusion in the end product standards for appliances that use electrolysers is given in informative Annex BB. Attention is drawn to the fact that for appliances intended to be used in vehicles or on board ships or aircraft, additional requirements can be necessary; in many countries, additional requirements are specified by the national health authorities, the national authorities responsible for the protection of labour, the national water supply authorities and similar authorities. This standard does not apply to appliances intended exclusively for industrial purposes; appliances intended to be used in locations where special conditions prevail, such as the presence of a corrosive or explosive atmosphere (dust, vapour or gas). – 10 – IEC 60335-2-108:2024 © IEC 2024
Contents:
- FOREWORD
- INTRODUCTION
- Scope