Household and similar electrical appliances – Safety – Part 2-124: Particular requirements for commercial dry ice blasting machines
Introduction: It has been assumed in the drafting of this International Standard that the execution of its provisions is entrusted to appropriately qualified and experienced persons. Guidance documents concerning the application of the safety requirements for appliances can be accessed via TC 61 and SC61J supporting documents on the IEC website https://www.iec.ch/tc61/supportingdocuments https://www.iec.ch/sc61j/supportingdocuments This information is given for the convenience of users of this International Standard and does not constitute a replacement for the normative text in this standard. This standard recognizes the internationally accepted level of protection against hazards such as electrical, mechanical, thermal, fire and radiation of appliances when operated as in normal use taking into account the manufacturer's instructions. It also covers abnormal situations that can be expected in practice and takes into account the way in which electromagnetic phenomena can affect the safe operation of appliances. This standard takes into account the requirements of IEC 60364 as far as possible so that there is compatibility with the wiring rules when the appliance is connected to the supply mains. However, national wiring rules can differ. If an appliance within the scope of this standard also incorporates functions that are covered by another part 2 of IEC 60335, the relevant part 2 is applied to each function separately, as far as is reasonable. If applicable, the influence of one functio
Scope: This clause of Part 1 is replaced by the following. This part of IEC 60335 deals with the safety of dry ice blasting machines intended for commercial indoor or outdoor use for the following hand-guided applications: cleaning, decoating, stripping of surfaces. The blasting machines are either equipped with containers for storage of dry ice or produce dry ice internally. These machines are not equipped with a traction drive. The following power systems are covered: mains powered motors up to a rated voltage of 250 V for single-phase appliances and 480 V for other appliances, battery-operated machines. This standard does not apply to dry ice blasting machines with integrated generation of compressed air; dry ice blasting machines using other transport gases besides compressed air or nitrogen; dry ice blasting machines with nozzles being controlled by robotic arms; spray extraction machines for commercial use (IEC 60335-2-68); high pressure cleaners (IEC 60335-2-79); sand blasting equipment (abrasive blasting); hand-held and transportable motor-operated electric tools (IEC 60745 series, IEC 61029 series, IEC 62841 series); machines designed for use in corrosive or explosive environments (dust, vapour or gas); machines designed for use in vehicles in non-ventilated environment; machines designed for use on board of ships or aircraft. NOTE 101 Attention is drawn to the fact that in many countries, additional requirements on the safe use of the equipment covered can be specified by the national health authorities, the national authorities responsible for the protection of labour and similar authorities. – 8 – IEC 60335-2-124:2024 © IEC 2024
Contents:
- FOREWORD
- INTRODUCTION
- Scope