Household and similar electrical appliances – Safety – Part 2-96: Particular requirements for flexible sheet heating elements for room heating (Commented Version)
Introduction: It has been assumed in the drafting of this International Standard that the execution of its provisions is entrusted to appropriately qualified and experienced persons. Guidance documents concerning the application of the safety requirements for appliances can be accessed via TC 61 supporting documents on the IEC website https://www.iec.ch/tc61/supportingdocuments This information is given for the convenience of users of this International Standard and does not constitute a replacement for the normative text in this standard. This standard recognizes the internationally accepted level of protection against hazards such as electrical, mechanical, thermal, fire and radiation of appliances when operated as in normal use taking into account the manufacturer's instructions. It also covers abnormal situations that can be expected in practice and takes into account the way in which electromagnetic phenomena can affect the safe operation of appliances. This standard takes into account the requirements of IEC 60364 as far as possible so that there is compatibility with the wiring rules when the appliance is connected to the supply mains. However, national wiring rules may can differ. If an appliance within the scope of this standard also incorporates functions that are covered by another part 2 of IEC 60335, the relevant part 2 is applied to each function separately, as far as is reasonable. If applicable, the influence of one function on the other is taken into account. When a part 2
Scope: This clause of Part 1 is replaced by the following. This part of IEC 60335 deals with the safety of flexible sheet heating elements intended to be incorporated into floors and walls below 1,2 m and above 2,3 m and in ceilings, their rated voltage being not more than 250 V for single-phase installations and 480 V for other installations including direct current (DC) supplied appliances. 3 Flexible sheet heating elements are converted into heating units that are incorporated in the building in accordance with the instructions after which the required level of protection against hazards is achieved. NOTE 101 Attention is drawn to the fact that in many countries, different wiring rules apply; for heating units intended to be used in vehicles or on-board ships or aircraft, additional requirements can be necessary; in many countries, additional requirements are specified by the national authorities for fire protection, the national authorities for building regulations, the national health authorities, the national authorities responsible for the protection of labour and similar authorities. NOTE 102 This standard does not apply to heating units intended exclusively for industrial purposes; heating units intended to be used in locations where special conditions prevail, such as the presence of a corrosive or explosive atmosphere (dust, vapour or gas); blankets, pads, clothing and similar flexible heating appliances (IEC 60335-2-17); foot warmers and heating mats (IEC 60335-2-81); heated carpets and for heating units for room heating installed under removable floor coverings (IEC 60335-2-106); flexible sheet heating elements incorporated in other appliances.
Contents:
- FOREWORD
- INTRODUCTION
- Scope