Solderless connections – Part 2: Crimped connections – General requirements, test methods and practical guidance
Introduction: This document includes requirements and relevant tests as well as practical guidance in Annex A for crimped connections. Two test schedules are provided: the basic test schedule which applies to solderless crimped connections which conform to all of the prerequisites of Clause 5. It is derived from experience with successful applications of such connections; the full test schedule which applies to solderless crimped connections which do not fully conform to all prerequisites of Clause 5, for example which are made with solid wires, using materials or finishes not included in Clause 4. This philosophy permits cost- and time-effective performance verification using a limited basic test schedule for established crimped connections and an expanded full test schedule for connections requiring more extensive performance validation. A detail product specification or the manufacturer's specification for crimped connections or associated cable assemblies or both, as well as for crimp contacts, terminal ends or splices, can include additional tests to verify enhanced performance or conformance with specified product classes or both. It can also reference this document with test severities and acceptance criteria other than those provided by either one of the two test schedules, as well as foresee an intermediate test schedule. The requirements of the detail product specification or the manufacturer's specification prevail. The suitability of the crimped connection implies that the spec
Scope: This part of IEC 60352 is applicable to solderless crimped connections made with: appropriately designed uninsulated or pre-insulated crimp barrels as parts of crimp contacts, terminal ends or splices, and stranded wires of 0,05 mm2 to 10 mm2 cross-section or solid wires of 0,25 mm to 3,6 mm diameter; for use in electrical and electronic equipment. Information on the materials and data from industrial experience is included in addition to the test procedures to provide electrically stable connections under prescribed environmental conditions. This part of IEC 60352 is not applicable to crimping of coaxial cables. This part of IEC 60352 determines the suitability of solderless crimped connections as described above, under specified mechanical, electrical and atmospheric conditions and provides a means of comparing test results when the tools used to make the connections are of different designs or manufacture.
Contents:
- FOREWORD
- INTRODUCTION
- Scope