IEC 60352-3-2020 PDF

IEC 60352-3-2020 PDF

Solderless connections-Part 3: Accessible insulation displacement (ID) connections-General requirements, test methods and practical guidance

$186.00 $371.99 -50%
Product Code: IEC 60352-3
Stock In Stock
Edition: 2.0
Published: 04/2020
Number of Pages: 86
File Size: 1 file, 5 Bytes

Available Options

Product Description

Solderless connections – Part 3: Accessible insulation displacement (ID) connections – General requirements, test methods and practical guidance

Introduction: The two following parts of IEC 60352 are available on solderless insulation displacement con- nections: Part 3: Accessible insulation displacement connections – General requirements, test methods and practical guidance; Part 4: Solderless non-accessible insulation displacement connections – General require- ments, test methods and practical guidance. NOTE In this document the term "insulation displacement" is abbreviated to "ID", for example "ID connection", "ID termination". Figure 1 illustrates examples of accessible and non-accessible insulation displacement con- nections that clarify the difference among them. Part 3 includes requirements and relevant tests (normative) as well as a practical guidance in Annex A (informative) for accessible ID connections. Two test schedules are provided: the basic test schedule which applies to insulation displacement connections which con- form to all prerequisites of Clause 5. It is derived from experience with successful applica- tions of such connections; the full test schedule which applies to insulation displacement connections which do not fully conform to all prerequisites of Clause 5, for example which are manufactured using materials or finishes not included in Clause 5. This philosophy permits cost and time effective performance verification using a limited basic test schedule for established insulation displacement connections and an expanded full test schedule for connections requiring more extensive performance validation. T

Scope: This part of IEC 60352 is applicable to ID connections which are accessible for tests and measurements according to Clauses 6 through 8 and which are made with: appropriately designed accessible ID terminations, wires having solid round conductors of 0,25 mm to 3,6 mm nominal diameter, wires having stranded conductors of 0,05 mm2 to 10 mm2 cross-sectional area, for use in electrical and electronic equipment and components. Information on materials and data from industrial experience is included in addition to the test procedures to provide electrically stable connections under prescribed environmental condi- tions. There are different designs and materials for accessible ID terminations in use. For this rea- son only fundamental parameters of the termination are specified, while the performance re- quirements of the wire and the complete connection are specified in full detail. The purpose of this document is: to determine the suitability of accessible ID connections under specified mechanical, elec- trical and atmospheric conditions; to provide a means of comparing test results when the tools used to make the connec- tions, if any, are of different designs or manufacture.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope
  • Introduction

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 60352-3-2020 PDF

IEC 60352-3-2020 PDF

$186.00 $371.99