IEC 60352-7-2026 PDF

IEC 60352-7-2026 PDF

Solderless connections - Part 7: Spring clamp connections - General requirements, test methods and practical guidance

$163.93 $327.86 -50%
Product Code: IEC 60352-7
Stock In Stock
Edition: 3.0
Published: 01/2026
Number of Pages: 78
File Size: 1 file, 2.7 MB

Available Options

Product Description

Solderless connections - Part 7: Spring clamp connections - General requirements, test methods and practical guidance

Introduction: This part of IEC 60352 covers spring clamp connections and includes requirements, tests and practical guidance information. Two test schedules are provided. a) The basic test schedule applies to spring clamp connections which conform to all requirements of Clause 5. These requirements are derived from experience with successful applications of such spring clamp connections. b) The full test schedule applies to spring clamp connections which do not fully conform to all requirements of Clause 5, for example which are manufactured using materials or finishes not included in Clause 5. This approach ensures cost and time effective performance verification using a limited basic test schedule for established spring clamp connections and an expanded full test schedule for spring clamp connections requiring more extensive performance validation. In this third edition, a dedicated test group providing requirements and tests for spring clamp connections with contact pressure transmitted via insulating material (CoPI) has been added in both test schedules, referring to the new Annex B (normative). In such instance, this provides means to fulfil both the requirement of 6.6.3 of IEC 61984:2008 concerning the design of electrical connections of connectors, and the requirement of 8.2 of IEC 60999-1:1999 concerning the design of clamping units connecting devices. The values given in this document are minimum values, which are harmonized with other IEC documents. Other standards or the manufac

Scope: This part of IEC 60352 is applicable to spring clamp connections made with stripped wire of the following types and sizes according to IEC 60228 or IEC 60189-3, without further preparation (later described “unprepared”): solid conductors (e.g. class 1 of IEC 60228) of 0,32 mm to 3,7 mm nominal diameter (0,08 mm2 to 10 mm2 cross-section), or stranded conductors (e.g. class 2 of IEC 60228) of 0,08 mm2 to 10 mm2 cross-section, or flexible conductors (e.g. class 5 or 6 of IEC 60228) of 0,08 mm2 to 10 mm2 cross-section, for use in electrical and electronic equipment and components. Information on materials and data from industrial experience is included in addition to the test procedures to provide electrically stable connections under prescribed environmental conditions. The object of this document is to determine the suitability of spring clamp connections under specified mechanical, electrical and atmospheric conditions. NOTE IEC Guide 109 advocates the need to minimize the impact of a product on the natural environment throughout the product life cycle. It is understood that some of the materials permitted in this document can have a negative environmental impact. As technological advances lead to acceptable alternatives for these materials, they will be eliminated from this document.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 60352-7-2026 PDF

IEC 60352-7-2026 PDF

$163.93 $327.86