Low voltage electrical installations – Part 7-712: Requirements for special installations or locations – Solar photovoltaic (PV) power supply systems
Introduction: For the purpose of this part of IEC 60364 (IEC 60364-7-712), the requirements of the general parts 1 to 6 of IEC 60364 apply. The IEC 60364-7-7XX parts of IEC 60364 contain particular requirements for special installations or locations which are based on the requirements of the general parts of IEC 60364 (IEC 60364-1 to IEC 60364-6). These IEC 60364-7-7XX parts are considered in conjunction with the requirements of the general parts. The particular requirements of this part of IEC 60364 supplement, modify or replace certain of the requirements of the general parts of IEC 60364 being valid at the time of publication of this part. The absence of reference to the exclusion of a part or a clause of a general part means that the corresponding clauses of the general requirements contained in parts 1 to 6 of IEC 60364 part are applicable (undated reference). Requirements of other 7XX parts being relevant for installations covered by this part also apply. This part may therefore also supplement, modify or replace certain of these requirements valid at the time of publication of this part. The clause numbering appearing after 712 refers to the corresponding parts or clauses of this part follows the pattern and corresponding references of IEC 60364. Numbering of clauses does not, therefore, necessarily follow sequentially. The numbers following the particular number of this part are those of the corresponding parts, or clauses of the other parts of the IEC 60364 series, valid at the ti
Scope: This part of IEC 60364 applies to the electrical installation of PV systems intended to supply all or part of an installation. The equipment of a PV installation, like any other item of equipment, is dealt with only so far as its selection and application in the installation is concerned. A PV installation starts from a PV module or a set of PV modules connected in series with their cables, provided by the PV module manufacturer, up to the user installation or the utility supply point (point of common coupling). Requirements of this document apply to PV installations not connected to a system for distribution of electricity to the public, PV installations in parallel with a system for distribution of electricity to the public, PV installations as an alternative to a system for distribution of electricity to the public, appropriate combinations of the above. This document does not cover the specific installation requirements for batteries or other energy storage methods. NOTE 1 Additional requirements for PV installations with battery storage capabilities on the DC side are under consideration. NOTE 2 This document does cover the protection requirements of PV arrays which develop as a result of the use of batteries in PV installations. For systems using DC-DC converters, additional requirements regarding voltage and current rating, switching, and protective devices can apply. These requirements are under consideration. The object of this document is to address the design safety requirements arising from the particular characteristics of PV installations. DC systems, and PV arrays in particular, pose some hazards in addition to those derived from conventional AC power installations, including the ability to produce and sustain electrical arcs with currents that are not greater than normal operating currents. In grid connected PV installations the safety requirements of this document are, however, critically dependent on the PCE associated with PV arrays complying with the requirements of IEC 62109-1 and IEC 62109-2. IEC 60364-7-712:2017 © IEC 2017 – 9 – 712.2
Contents:
- FOREWORD
- INTRODUCTION
- 712 Solar photovoltaic (PV) power supply systems installations
- Scope
- 712.312 Types of distribution systems
- Introduction
- 712.413 Fault protection
- 712.433 Protection against overload on the DC side current
- 712.434 Protection against short-circuit currents
- 712.444 Protection Measures against electromagnetic interference (EMI) in
- 712.511 Compliance with standards
- 712.512 Operational conditions and external influences
- 712.522 Selection and erection of wiring systems in relation to external influences