Nuclear instrumentation – Nomenclature (identification) of scintillators and scintillation detectors and standard dimensions of scintillators
Introduction: Recently each manufacturer of scintillation detectors has been offering its own nomenclature presenting in it, in the first place, their trademarks and introducing their own abbreviations (identification). The nomenclature of scintillators and scintillation detectors is quite complicated and usually includes type of detector, scintillator’s material, geometry and dimensions of scintillator, materials of housing and window, type and dimensions of photomultiplier tube or photodiode, presence of additional electronic devices and some other characteristics. Different manufacturers offer different content and different order of characteristic designations in the identifiers of their products. This makes perception by a customer of the meaning of symbols in these identifiers difficult. The situation can be improved through introducing a uniform system of nomenclature (identification) of scintillators and scintillation detectors. For this purpose it is advisable to use designations of separate parameters in a strict order, guided by a principle: from the main parameters to secondary ones. This approach will introduce uniformity into the system of nomenclature (identification) of scintillators and scintillation detectors, as well as facilitate the perception of this system and correct selection of products by the customer.
Scope: This International Standard gives guidelines for scintillation detectors and scintillators nomenclature (identification) and standard dimensions of scintillators. This International Standard is applicable to all types of solid organic and inorganic scintillators used in detectors for scintillation counting and spectrometry. The object of this standard is to define a standardized nomenclature for scintillation detectors in which most of the properties can be found. The object of this standard is to standardize the dimensions of bare scintillators in order to facilitate interchangeability of non-encapsulated scintillators and to facilitate intercomparisons of measurements with encapsulated scintillators. Liquid scintillators are not addressed by this standard. NOTE The identification labels laid down in Clause 2 of the present standard include certain dimensions which may be expressed in millimetres or inches. The SI system recommends the use of millimetres rather than inches. Nomenclature of scintillation detectors and scintillators 2.1 General The identification of a scintillation detector is specified by a predefined sequence of specification items described below. Each specification item refers to a specific property of the detector material and/or construction. The general structure of an identification label includes symbols, described in 2.2 to 2.13, and given in the same order in which these subclauses are provided. 2.2 Configuration This definition is producer-specific, for example: – crystal without photomultiplier (see example 1 at the end of this clause); HC – housed crystal (see example 2); HCW – housed crystal with a well; HCH – housed crystal with a hole; IMP – housed crystal with integrally mounted photomultiplier (see examples 3 to 5); PhX – phoswich, where X is the number of scintillators (see example 6); X CH Y – single-line X-channels detector (see example 7), where X is the number of channels in line; Y is pitch. 2.3 Geometry of the scintillator – cubic; – rectangular; – 14 – IEC 60412:2014 © IEC 2014 AVANT-PROPOS .................................................................................................................. 15 INTRODUCTION
Contents:
- FOREWORD
- INTRODUCTION
- Scope