Ferrite cores – Guide on the limits of surface irregularities – Part 5: Planar-cores
Scope: This part of IEC 60424 gives guidance on allowable limits of surface irregularities of ferrite cores. This standard is considered as a general specification useful in the negotiation between ferrite core manufacturers and customers about surface irregularities. General Due to the method of manufacture and the physical nature of the products, ferrite cores can be expected to exhibit some degree of physical surface irregularities such as chips, ragged edges, cracks, flashes and pull-outs. The permissible extent of these surface irregularities will depend on the type, position and size of the defect and on the function of the core. Thus, if it is required to establish limits of surface irregularities for a given series of ferrite cores, for example RM-cores, pot-cores, E-cores, U- cores and ring-cores, etc., it would be necessary to prepare a particular specification setting out in great detail the permissible extent of the various types of irregularities. All surfaces of the core should be clean and free from loose ferrite particles or any other foreign matter. This applies mainly to the contact surfaces. Stains, discolorations, surface crazing or crystallization are acceptable if they do not affect the normal performance of the core. The irregularities described below are considered as being detectable without the use of any magnifying equipment. Definitions of surface irregularities 3.1 chips and ragged edges chips and ragged edges are areas with missing surface material and are generally caused by mechanical impact during handling (transportation, sorting, feeding, etc.) or grinding. Therefore, in almost all cases, they are located on the edges of surfaces (see figure 1). The ragged edges should be considered as a series of small chips having a width less than 1 mm. 3.2 crack surface irregularity which has a width much smaller than its length, and penetrates into the core. Cracks can therefore be limited by their length and their location (see figure 1) 3.3 flash sharp feather-edge wall extending beyond the intended contour surface of the core (see figure 1)
Contents: