IEC 60475-2022 PDF

IEC 60475-2022 PDF

Method of sampling insulating liquids

$132.41 $264.81 -50%
Product Code: IEC 60475
Stock In Stock
Edition: 3.0
Published: 05/2022
Number of Pages: 64
File Size: 1 file, 1 Byte

Available Options

Product Description

Method of sampling insulating liquids

Introduction: General caution, health, safety and environmental protection WARNING – This document does not purport to address all the safety problems associated with its use. It is the responsibility of the user of this document to establish appropriate health and safety practices and determine the applicability of regulatory limitations prior to use. The insulating oils which are the subject of this document should be handled with due regard to personal hygiene. Direct contact with the eyes can cause irritation. In the case of eye contact, irrigation with copious quantities of clean running water should be carried out and medical advice sought. Some of the tests specified in this document involve the use of processes that could lead to a hazardous situation. Attention is drawn to the relevant standard for guidance. This document is applicable to mineral oils and non-mineral oils, chemicals and used sample containers. Attention is drawn to the fact that some mineral oils in service can still be contaminated to some degree by PCBs. If this is the case, safety countermeasures should be taken to avoid risks to workers, the public and the environment during the life of the equipment, by strictly controlling spills and emissions. The disposal or decontamination of these oils can be subject to regulatory requirements with regard to their impact on the environment. Every precaution should be taken to prevent release of mineral oil and non-mineral oil into the environment.

Scope: This document is applicable to the sampling procedure used for insulating liquids in delivery containers and in electrical equipment such as power and instrument transformers, reactors, bushings, oil-filled cables, oil-filled tank-type capacitors, switchgear and load tap changers (LTCs). This document applies to liquids the viscosity of which at the sampling temperature is less than 1 500 mm2/s (or cSt). It applies to mineral oils and non-mineral oils (such as synthetic esters, natural esters, vegetable oils or silicones).

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 60475-2022 PDF

IEC 60475-2022 PDF

$132.41 $264.81