Methods of measurement for radio equipment used in satellite earth stations Part 1: Measurements common to sub-systems and combinations of sub-systems Section Two: Measurements in the r.f. range
Introduction: It is not possible to describe fully the precautions necessary to obtain quantitative results of acceptable accuracy for all possible cases which may be covered by the types of measurements given below but attention is drawn to the following cases of general interest. The possible presence of spurious signals, including harmonics, at the ports where the test signals are applied should not be overlooked. These spurious signals could disturb the operation of the test equipment or the system or sub-system under test. Consideration should be given to the removal of undesired signals at the test ports because although their amplitudes may be insufficient to affect the test arrangement, their presence may modify the r.f. characteristics to be measured, for example by the generation of heat. Changes to the mechanical mounting of sub-assemblies including ferrite isolators and circulators, or changes to the location of r.f. screens, should not be made unless it is certain that the ensuing overall performance will adequately represent the performance of the system or sub-system which is being simulated. In the following methods of measurement, no reference will be made to the requirements for protecting the test arrangement against possible r.f. interference. When sweep-frequency measurements are made, the pass-band of the test receiver (the selective amplifier, amplitude detector and oscilloscope) should be of the order of 50 to 100 times the repetition rate of the frequency sweep, de
Scope: This section deals with measurements normally made at radio frequencies (r.f.), for transmitting and receiving equipment used in earth stations for communication through orbiting satellites. It applies both to sub-systems and to combinations of sub-systems. 2. Introduction It is not possible to describe fully the precautions necessary to obtain quantitative results of acceptable accuracy for all possible cases which may be covered by the types of measurements given below but attention is drawn to the following cases of general interest. The possible presence of spurious signals, including harmonics, at the ports where the test signals are applied should not be overlooked. These spurious signals could disturb the operation of the test equipment or the system or sub-system under test. Consideration should be given to the removal of undesired signals at the test ports because although their amplitudes may be insufficient to affect the test arrangement, their presence may modify the r.f. characteristics to be measured, for example by the generation of heat. Changes to the mechanical mounting of sub-assemblies including ferrite isolators and circulators, or changes to the location of r.f. screens, should not be made unless it is certain that the ensuing overall performance will adequately represent the performance of the system or sub-system which is being simulated. In the following methods of measurement, no reference will be made to the requirements for protecting the test arrangement against possible r.f. interference. When sweep-frequency measurements are made, the pass-band of the test receiver (the selective amplifier, amplitude detector and oscilloscope) should be of the order of 50 to 100 times the repetition rate of the frequency sweep, depending upon the waveform of the sweep signal. It is the responsibility of those conducting the tests to arrange the test equipment as necessary in order to keep measurement errors within permissible limits. When presenting the results of the measurements described in the following clauses, it is advisable to provide a diagram of the actual test arrangement employed—showing loads, isolators, low-pass filters and other deta
Contents: