IEC 60534-5-2004 PDF

IEC 60534-5-2004 PDF

Industrial-process control valves-Part 5: Marking

$25.22 $50.44 -50%
Product Code: IEC 60534-5
Stock In Stock
Edition: 2.0
Published: 02/2004
Number of Pages: 26
File Size: 1 file, 543 Bytes

Available Options

Product Description

Industrial-process control valves – Part 5: Marking

Introduction: Identification of the correct type of control valve for a particular industrial-process control valve application requires that information denoting significant parameters of the valve be located on the valve. The methods of marking the information, based upon provisions of EN 19 and ISO 5209, are described in this part of IEC 60534.

Scope: This part of IEC 60534 specifies mandatory and supplementary markings of control valves. Some mandatory markings may be inappropriate for some valves of special design, and some supplementary markings may be appropriate only to specific types of control valves. It is recommended that the marking of all valves conform to this standard whenever possible unless otherwise agreed between the manufacturer and purchaser. Mandatory markings should be located in such a way that markings remain permanent. Mandatory markings shall be integral with the valve body or on a marking plate (distinct from an identification plate) securely fixed to the body. The location of supplementary markings is also specified. Usually, these are on an identification plate.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 60534-5-2004 PDF

IEC 60534-5-2004 PDF

$25.22 $50.44