Quartz crystal controlled oscillators of assessed quality – Part 6: Phase jitter measurement method for quartz crystal oscillators and SAW oscillators – Application guidelines
Introduction: The study of phase jitter measurement methods was conducted in accordance with the agreement during the IEC TC 49 Berlin international meeting in 2001. At this meeting, the decision was made that Japan should assume the responsibilities of this study. Then, the technical committee of the Quartz Crystal Industry Association of Japan (QIAJ) proceeded with this study. This study was substantially conducted during the years 2002 to 2005 and can be referred to as the first stage of the study. The second stage is being continued at present. Phase jitter has become one of the essential measurement items by digitization of electronic devices. However, theoretically, some ambiguity is still left in the phase jitter. Since no standard measurement method is proposed, suppliers and customers may be mutually exposed to a risk which could cause enormous economic losses. To avoid this risk, this document provides a standard, based on the study results during the first stage, for each company of QIAJ members to avoid anxiety as to the measurement of the phase jitter and for the purpose of giving guidance without any mistakes. In this standard, a recommendation to make r.m.s. jitter a measurement object is presented. The reason why this recommendation is submitted is because the oscillators resulting in ultra- low amount of jitter are targeted as the object to be measured. Oscillators are analogue-type electronic devices. Their sine wave output signals are more favourable than the signals obt
Scope: This part of the IEC 60679 series applies to the phase jitter measurement of quartz crystal oscillators and SAW oscillators used for electronic devices and gives guidance for phase jitter that allows the accurate measurement of r.m.s. jitter. In the measurement method, phase noise measurement equipment or a phase noise measurement system is used. The measuring frequency range is from 10 MHz to1 000 MHz. This standard applies to quartz crystal oscillators and SAW oscillators used in electronic devices and modules that have the multiplication or division functions based on these oscillators. The type of phase jitter applied to these oscillators is the r.m.s. jitter. In the following text, these oscillators and modules will be referred to as “oscillator(s)” for simplicity.
Contents:
- FOREWORD
- INTRODUCTION
- Scope