Flexible Insulating Sleeving - Part 3: Specifications for Individual Types of Sleeving - Sheets 100 to 105: Extruded PVC Sleeving
Introduction: This standard is one of a series which deals with flexible insulating sleeving for electrical purposes. The series consists of three parts: – Part 1: Definitions and general requirements (IEC 60684-1); – Part 2: Methods of test (IEC 60684-2); – Part 3: Specifications for individual types of sleeving (IEC 60684-3). This standard gives six of the sheets comprising Part 3 as follows: – Sheet 100: Extruded PVC sleeving – General purpose grade – Bilateral tolerances – Sheet 101: Extruded PVC sleeving – High temperature grade – Bilateral tolerances – Sheet 102: Extruded PVC sleeving – Low temperature grade – Bilateral tolerances – Sheet 103: Extruded PVC sleeving – General purpose grade – Unilateral tolerances – Sheet 104: Extruded PVC sleeving – High temperature grade – Unilateral tolerances – Sheet 105: Extruded PVC sleeving – Low temperature grade – Unilateral tolerances
Scope: This standard gives the requirements for three types of non-heatshrinkable sleeving, extruded from PVC. Sleeving of this type is normally available with an internal diameter up to 50 mm and in a range of wall thicknesses between 0,2 mm and 1,8 mm. Each sheet covers up to three levels of wall thickness, "thin wall", "standard wall" and "thick wall" related to nominal internal diameter and with corresponding differences in requirements for breakdown voltage. Sheets 100 and 103 cover sleeving having a temperature range of −10 °C to 90 °C. Sheets 101 and 104 cover sleeving having a temperature range of −10 °C to 105 °C. Sheets 102 and 105 cover sleeving having a temperature range of −40 °C to 70 °C. These sleevings are normally available in the following opaque colours: black, brown, red, orange, yellow, green, blue, violet, grey, white, pink, turquoise and green/yellow. They are also available in a transparent, translucent and non-coloured form. Sizes and colours other than those specifically listed in this standard may be available as custom items. These items shall be considered to comply with this standard if they comply with the other property requirements listed in table 5.