Flexible Insulating Sleeving - Part 3: Specifications for Individual Types of Sleeving - Sheets 121 and 124: Extruded Silicone Sleeving
Introduction: This International Standard is one of a series which deals with flexible insulating sleeving for electrical purposes. The series consists of three parts: Part 1 : Definitions and general requirements (IEC 60684-1); Part 2 : Methods of test (IEC 60684-2); Part 3 : Specification requirements for individual types of sleeving (IEC 60684-3). This standard contains four of the sheets comprising part 3 as follows: Sheet 121: Extruded silicone sleeving – General purpose, flame retarded Sheet 122: Extruded silicone sleeving – General purpose, flame retarded, low volatile content Sheet 123: Extruded silicone sleeving – General purpose Sheet 124: Extruded silicone sleeving – General purpose, low volatile content.
Scope: These sheets of IEC 60684-3 gives the requirements for four types of non-heatshrinkable sleeving, extruded from silicone elastomer. These sleevings are normally available with internal diameter up to 25 mm and in a range of wall thicknesses between 0,1 mm and 2,0 mm. National standards may select a restricted list of preferred combinations of internal diameter and wall thickness. These sleevings are normally available in the following opaque colours: black, brown, red, orange, yellow, green, blue, violet, grey, white and pink. They are also available in a translucent form. Sizes or colours other than those specifically listed in this standard may be available as custom items. These items shall be considered to comply with this standard if they comply with the other property requirements listed in table 2.