IEC 60684-3-240 TO 243-2002 PDF

IEC 60684-3-240 TO 243-2002 PDF

Flexible Insulating Sleeving - Part 3: Specifications for Individual Types of Sleeving - Sheets 240 to 243: Heat-Shrinkable PTFE Sleeving

$25.22 $50.44 -50%
Product Code: IEC 60684-3-240 TO 243
Stock In Stock
Edition: 2.0
Published: 06/2002
Number of Pages: 26
File Size: 1 file, 608 Bytes

Available Options

Product Description

Flexible Insulating Sleeving - Part 3: Specifications for Individual Types of Sleeving - Sheets 240 to 243: Heat-Shrinkable PTFE Sleeving

Introduction: This International Standard is one of a series which deals with flexible insulating sleeving for electrical purposes. The series consists of three parts: Part 1: Definitions and general requirements (IEC 60684-1); Part 2: Methods of test (IEC 60684-2); Part 3: Specifications for individual types of sleeving (IEC 60684-3). This standard gives four of the sheets comprising Part 3 as follows: Sheet 240: Heat-shrinkable PTFE sleeving, low shrink ratio, thick wall Sheet 241: Heat-shrinkable PTFE sleeving, low shrink ratio, medium wall Sheet 242: Heat-shrinkable PTFE sleeving, low shrink ratio, thin wall Sheet 243: Heat-shrinkable PTFE sleeving, high shrink ratio.

Scope: These sheets of IEC 60684-3 give the requirements for heat-shrinkable (low and high shrink ratio) polytetrafluorethylene (PTFE) sleeving. It is normally available in expanded internal diameter sizes up to 12 mm in three wall thickness ranges as supplied in the low shrink ratio (sheets 240, 241 and 242) and up to 100 mm in one wall thickness range as supplied in the high shrink ratio (sheet 243). It is normally available in transparent milk white to light tan in colour and the minimum recovery temperature is 350 °C. The procedures described in IEC 60216-1 for evaluation of thermal endurance are not readily applicable to PTFE: however, experience of product performance indicates that this sleeving may be suitable for inclusion in systems for operation at temperatures up to 250 °C. Sizes other than those specifically listed in this standard may be available as custom items. The items shall be considered to comply with this standard if they comply with the property requirements listed in tables 3 and 4. Materials which conform to this specification meet established levels of performance. However, the selection of a material by a user for a specific application should be based on the actual requirements necessary for adequate performance in that application and not based on this specification alone.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 60684-3-240 TO 243-2002 PDF

IEC 60684-3-240 TO 243-2002 PDF

$25.22 $50.44