Fire hazard testing - Part 1-20: Guidance for assessing the fire hazard of electrotechnical products - Ignitability - General guidance
Introduction: Fires are responsible for creating hazards to life and property as a result of the generation of heat (thermal hazard), and also as a result of the production of toxic effluent, corrosive effluent and smoke (non-thermal hazard). Fires start with ignition and then can grow, leading in some cases to flash-over and a fully developed fire. Ignition resistance is therefore one of the most important parameters of a material to be considered in the assessment of fire hazard. If there is no ignition, there is no fire. For most materials (other than metals and some other elements), ignition occurs in the gas phase. Ignition occurs when combustible vapour, mixed with air, reaches a high enough temperature for exothermic oxidation reactions to rapidly propagate. The ease of ignition is a function of the chemical nature of the vapour, the fuel/air ratio and the temperature. In the case of liquids, the combustible vapour is produced by vaporization of the liquid, and the vaporization process is dependent on the temperature and chemical composition of the liquid. In the case of solids, the combustible vapour is produced by pyrolysis when the temperature of the solid is sufficiently high. The vaporization process is dependent on the temperature and chemical composition of the solid, and also on the thickness, density, specific heat, and thermal conductivity of the solid. The ease of ignition of a test specimen depends on many variables. Factors to be considered for the assessment of ignitab
Scope: This part of IEC 60695 provides guidance on the ignitability of electrotechnical products and the materials from which they are formed. It gives guidance on: a) the principles of ignitability; b) the selection of appropriate test methods, and c) the use and interpretation of results. This part of IEC 60695 is intended for use by technical committees in preparation of standards in accordance with the principles laid down in IEC Guide 104 and ISO/IEC Guide 51. One of the responsibilities of a technical committee is, wherever applicable, to make use of basic safety publications in the preparation of its publications. The requirements, test methods or test conditions of this basic safety publication will not apply unless specifically referred to or included in the relevant publications.
Contents:
- FOREWORD
- INTRODUCTION
- Scope