IEC 60695-10-3-2016 PDF

IEC 60695-10-3-2016 PDF

Fire hazard testing-Part 10-3: Abnormal heat-Mould stress relief distortion test

$25.22 $50.44 -50%
Product Code: IEC 60695-10-3
Stock In Stock
Edition: 2.0
Published: 09/2016
Number of Pages: 26
File Size: 1 file, 331 Bytes

Available Options

Product Description

Fire hazard testing – Part 10-3: Abnormal heat – Mould stress relief distortion test

Introduction: In the design of any electrotechnical product, the risk of abnormal heat and the potential hazards associated with abnormal heat need to be considered. In this respect the objective of component, circuit, and product design, as well as the choice of materials, is to reduce to acceptable levels the potential risks during normal operating conditions, reasonable foreseeable abnormal use, malfunction and/or failure. The IEC has developed IEC 60695-1-10, together with its companion, IEC 60695-1-11, to provide guidance on how this is to be accomplished. The primary aims of IEC 60695-1-10 [1]1 and IEC 60695-1-11 [2] are to provide guidance on how: a) to prevent ignition caused by an electrically energized component part, and b) to confine any resulting fire within the bounds of the enclosure of the electrotechnical product in the event of ignition. Secondary aims of IEC 60695-1-10 and IEC 60695-1-11 include the minimization of any flame spread beyond the product’s enclosure and the minimization of the harmful effects of fire effluents such as heat, smoke, toxicity and/or corrosivity. Fires involving electrotechnical products can also be initiated from external non-electrical sources. Considerations of this nature should be dealt with in the overall fire hazard assessment. This part of IEC 60695 describes a test method that simulates the effects caused by relief of the residual process-induced stress, frozen in a moulded polymeric assembly of an end product, when the end product or a

Scope: This part of IEC 60695 specifies a mould stress relief distortion test. It is applicable to electrotechnical equipment including parts made from polymeric materials. This test method is intended to evaluate the effects caused by relief of the residual process- induced stress, set in a moulded polymeric assembly of an end product. This stress relief occurs when the sample (energized or not), is exposed to conditioning at a defined temperature for a defined period of time. The test specimen is considered to have satisfactorily withstood the test if, after conditioning to room temperature, it meets defined test criteria. This basic safety publication is primarily intended for use by technical committees in the preparation of standards in accordance with the principles laid down in IEC Guide 104 and ISO/IEC Guide 51. It is not intended for use by manufacturers or certification bodies. One of the responsibilities of a technical committee is, wherever applicable, to make use of basic safety publications in the preparation of its publications. The requirements, test methods or test conditions of this basic safety publication will not apply unless specifically referred to or included in the relevant publications.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 60695-10-3-2016 PDF

IEC 60695-10-3-2016 PDF

$25.22 $50.44