Cable networks for television signals, sound signals and interactive services - Part 12: Electromagnetic compatibility of systems
Introduction: Standards and deliverables of the IEC 60728 series deal with cable networks including equipment and associated methods of measurement for headend reception, processing and distribution of television and sound signals, and for processing, interfacing and transmitting all kinds of data signals for interactive services using all applicable transmission media. These signals are typically transmitted in networks by frequency-multiplexing techniques. This includes, for instance: regional and local broadband cable networks, extended satellite and terrestrial television distribution systems, individual satellite and terrestrial television receiving systems, and all kinds of equipment, systems and installations used in such cable networks, distribution and receiving systems. The extent of this standardization work is from the antennas and/or special interfaces to the headend or other interface points to the network up to any terminal interface of the equipment on the customer's premises. The standardization work will consider coexistence with users of the RF spectrum in wired and wireless transmission systems. The standardization of any user terminals (i.e. tuners, receivers, decoders, multimedia terminals, etc.) as well as of any coaxial, balanced and optical cables and accessories thereof is excluded.
Scope: This part of IEC 60728 applies to the radiation characteristics and immunity to electromagnetic disturbance of cable networks for television signals, sound signals and interactive services and covers the frequency range 0,15 MHz to 3,5 GHz. NOTE 1 Measurements below 30 MHz are not generally considered useful in the context of cable networks and are difficult to perform in practice. This document specifies methods of measurement and EMC performance requirements under operating conditions (in situ) to ensure the ongoing EMC integrity of cable networks. Cable networks beyond the system outlets (e.g. the receiver lead, in simplest terms) that begin at the system outlet and end at the input to the subscriber's terminal equipment are not covered by this document. Requirements for the electromagnetic compatibility of receiver leads are specified in IEC 60966-2-4, IEC 60966-2-5 and IEC 60966-2-6. Cable networks and a wide range of radio services have to coexist. These include, for example, the emergency services, safety of life, broadcasting, aeronautical, radio navigation services and also land, mobile, amateur and cellular radio services. Frequency ranges of typical safety of life services are listed in Annex B. Additional protection for certain services may be required by national regulations. Annex A gives information on legal requirements in certain countries.
Contents:
- FOREWORD
- INTRODUCTION
- Scope
- 3 m