IEC 60728-4-2007 PDF

IEC 60728-4-2007 PDF

Cable networks for television signals, sound signals and interactive services-Part 4: Passive wideband equipment for coaxial cable networks

$163.93 $327.86 -50%
Product Code: IEC 60728-4
Stock In Stock
Edition: 3.0
Published: 08/2007
Number of Pages: 36
File Size: 1 file, 858 Bytes

Available Options

Product Description

Cable networks for television signals, sound signals and interactive services – Part 4: Passive wideband equipment for coaxial cable networks

Introduction: Standards of the IEC 60728 series deal with cable networks including equipment and associated methods of measurement for headend reception, processing and distribution of television signals, sound signals and their associated data signals and for processing, interfacing and transmitting all kinds of signals for interactive services using all applicable transmission media. This includes CATV1-networks; MATV-networks and SMATV-networks; individual receiving networks; and all kinds of equipment, systems and installations installed in such networks. The extent of this standardization work is from the antennas and/or special signal source inputs to the headend or other interface points to the network up to the terminal input. The standardization of any user terminals (i.e., tuners, receivers, decoders, multimedia terminals, etc.) as well as of any coaxial, balanced and optical cables and accessories thereof is excluded. ————————— 1 This word encompasses the HFC networks used nowadays to provide telecommunications services, voice, data, audio and video both broadcast and narrowcast.

Scope: This part of IEC 60728 applies to system outlets, splitters and taps, passive single or multiple port equipment comprising filters, attenuators, equalizers, galvanic isolators, power injectors, cable splices, terminating resistors and transfer points, but excluding coaxial cables and receiver leads (see 5.2). This standard covers the frequency range 5 MHz to 3 000 MHz; identifies performance requirements for certain parameters; lays down data publication requirements for certain parameters; stipulates methods of measurements; introduces minimum requirements defining quality grades. There are three grades for all passive equipment except system outlets where there is only one. Different networks require the same performance and, when integrating networks, upgrading will be avoided. Practical experience has shown that these three grades meet most of the technical requirements necessary for supplying a minimum signal quality to the subscribers. This classification should not be considered as a requirement but as information for users and manufacturers on the minimum quality criteria of the material required to install networks of different sizes. The system operator should select appropriate material to meet the minimum signal quality at the subscriber's outlet and to optimize cost/performance, taking into account the size of the network and local circumstances. All requirements and published data should be understood as guaranteed values within the specified frequency range and in well-matched conditions.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 60728-4-2007 PDF

IEC 60728-4-2007 PDF

$163.93 $327.86