Cable networks for television signals, sound signals and interactive services – Part 7-1: Hybrid Fibre Coax Outside Plant status monitoring – Physical (PHY) Layer Specification
Introduction: Standards of the IEC 60728 series deal with cable networks for television signals, sound signals and interactive services including equipment, systems and installations for head-end reception, processing and distribution of television and sound signals and their associated data signals, and processing, interfacing and transmitting all kinds of signals for interactive services using all applicable transmission media. All kinds of networks like CATV-networks, MATV-networks and SMATV-networks, individual receiving networks and all kinds of equipment, systems and installations installed in such networks, are within this scope. Standards and other deliverables of the IEC 60728 series deal with cable networks including equipment and associated methods of measurement for headend reception, processing and distribution of television and sound signals and for processing, interfacing and transmitting all kinds of data signals for interactive services using all applicable transmission media. These signals are typically transmitted in networks by frequency-multiplexing techniques. This includes for instance regional and local broadband cable networks, extended satellite and terrestrial television distribution systems, individual satellite and terrestrial television receiving systems, and all kinds of equipment, systems and installations used in such cable networks, distribution and receiving systems. The extent of this standardization work is from the antennas, and/or special signal sourc
Scope: This part of IEC 60728 specifies requirements for The Hybrid Fibre Coax (HFC) Outside Plant (OSP) Physical (PHY) Layer Specification and is part of the series of specifications developed by the Hybrid Management Sub-Layer (HMS) subcommittee under the SCTE. The purpose of the HMS specification is to support the design and implementation of interoperable management systems for evolving HFC cable networks. The HMS Physical (PHY) Layer Specification describes the physical layer portion of the protocol stack used for communication between HMS-compliant transponders interfacing to managed outside plant network elements (NE) and a centralized head-end element (HE). This standard describes the PHY layer requirements that must be implemented by all Type 2 and Type 3 compliant OSP HMS transponders on the HFC plant and the controlling equipment in the head-end. Any exceptions to compliance with this standard will be specifically noted herein as necessary. Refer to Table 1 for a full definition of the type classifications. Electromagnetic Compatibility (EMC) is not specified in this standard and is left to the vendor to ensure compliance with local EMC regulatory requirements. Other than operating temperature, physical parameters such as shock, vibration, humidity, etc., are also not specified and left to the vendor’s discretion. Transponder type classifications referenced within the HMS series of standards are defined in Table 1. Table 1 – Transponder type classifications Type Description Application Type 0 Refers to legacy transponder equipment, which is incapable of supporting the HMS specifications This transponder interfaces with legacy network equipment through proprietary means. This transponder could be managed through the same management applications as the other types through proxies or other means at the head-end Type 1 Refers to stand-alone transponder equipment (legacy or new) which can be upgraded to support the HMS specifications This transponder interfaces with legacy network equipment through proprietary means. Type 1 is a standards-compliant transponder (either manufactured to the standard or upgraded) that connects to legacy network equipment via a propri
Contents:
- FOREWORD
- INTRODUCTION
- Scope
- 3.10 Abbreviated terms