IEC 60749-16-2003 PDF

IEC 60749-16-2003 PDF

Semiconductor Devices - Mechanical and Climatic Test Methods - Part 16: Particle Impact Noise Detection (PIND)

$15.77 $31.53 -50%
Product Code: IEC 60749-16
Stock In Stock
Edition: 1.0
Published: 01/2003
Number of Pages: 22
File Size: 1 file, 204 Bytes

Available Options

Product Description

Semiconductor Devices - Mechanical and Climatic Test Methods - Part 16: Particle Impact Noise Detection (PIND)

Scope: The purpose of this part of IEC 60749 is to detect the presence of loose particles inside a cavity device such as, for example, chips of ceramic, pieces of bonding wire or solder balls (prills). The test of particle impact noise detection is classified as non-destructive. Terms and definitions For the purposes of this part of IEC 60749, the following definitions apply. 2.1 run test of all the individual devices of the lot under test which passed the previous run NOTE The first run includes all the devices of the lot under test, the subsequent runs will include only the devices which passed the previous run(s) and will exclude all the devices which failed. General remarks An acoustic transducer is attached to the test specimen via an acoustic coupling medium and its output fed via a suitable amplifier to an audio/visual monitoring system. The test specimen is subjected to sinusoidal vibration and a series of controlled mechanical shocks by a suitable mechanical shaker and shock mechanism/impact tool. As a result of this mechanical stimulation, loose particles within the cavity of the test specimen will impact the internal walls of the cavity, producing noise which will be detected by the acoustic transducer and indicated by the monitoring system. Equipment The following equipment and/or materials (or their equivalents) is required: a) Vibration shaker (sinusoidal). Output: 200 m/s2 peak at 40 Hz – 250 Hz. b) Mechanical shock mechanism/tool. Shock pulse: 10 000 m/s2 ± 2 000 m/s2 peak. Main shock duration: 100 µs maximum. NOTE 1 The application of vibration and shock is most practical through the use of an integral vibration/shock system (co-test system). Where a co-test system is used the interruption to the vibration source during the mechanical shock should not exceed 250 ms from initiation of the last shock pulse in the sequence; and the duration of this shock test should be measured at the 50 ± 5 % points.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 60749-16-2003 PDF

IEC 60749-16-2003 PDF

$15.77 $31.53