Semiconductor devices – Mechanical and climatic test methods – Part 37: Board level drop test method using an accelerometer
Introduction: Handheld electronic products fit into the consumer and portable market segments. Included in handheld electronic products are cameras, calculators, cell phones, cordless phones, pagers, palm size PCs, personal computer memory card international association (PCMCIA) cards, smart cards, personal digital assistants (PDAs) and other electronic products that can be conveniently stored in a pocket and used while held in user’s hand. These handheld electronic products are more prone to being dropped during their useful service life because of their size and weight. This dropping event can not only cause mechanical failures in the housing of the device but also create electrical failures in the printed circuit board (PCB) assemblies mounted inside the housing due to transfer of energy through PCB supports. The electrical failures may sometimes result from various failure modes such as cracking of the circuit board, track cracking on the board, cracking of solder interconnections between the components and the board, and component cracks. The primary driver of these failures is excessive flexing of the circuit board due to input acceleration to the board created from dropping the handheld electronic product. This flexing of the board causes relative motion between the board and the components mounted on it, resulting in component, interconnect or board failures. The failure is a function of the combination of the board design, construction, material, thickness and surface finish; inte
Scope: This part of IEC 60749 provides a test method that is intended to evaluate and compare drop performance of surface mount electronic components for handheld electronic product applications in an accelerated test environment, where excessive flexure of a circuit board causes product failure. The purpose is to standardize the test board and test methodology to provide a reproducible assessment of the drop test performance of surface-mounted components while producing the same failure modes normally observed during product level test. This document aims at prescribing a standardized test method and reporting procedure. This is not a component qualification test and is not meant to replace any system level drop test that is sometimes used to qualify a specific handheld electronic product. The standard is not meant to cover the drop test required to simulate shipping and handling-related shock of electronic components or PCB assemblies. These requirements are already addressed in test methods such as IEC 60749-10. The method is applicable to both area array and perimeter-leaded surface mounted packages. This test method uses an accelerometer to measure the mechanical shock duration and magnitude applied which is proportional to the stress on a given component mounted on a standard board. The test method described in IEC 60749-40 uses strain gauge to measure the strain and strain rate of a board in the vicinity of a component. The customer specification states which test method is to be used.
Contents: