General safety requirements for residual current operated protective devices
Introduction: IEC 60755 has been prepared as a Group Safety Publication by subcommittee 23E in accordance with its Group Safety Function for residual current devices. It is intended for use by technical committees in the preparation of standards for residual current unit, function or devices when it is intended to provide protective measures according to IEC 60364 (all parts). There are two basic conditions of protection against the risk of electric shock: fault protection (indirect contact) and basic protection (direct contact). Fault protection implies that the device is used to prevent dangerous voltages persisting on accessible installation metalworks, which are earthed but become live under earth fault conditions. Under such conditions, the risk arises not from the user making direct contact with a live conductive part, but making contact with earthed metalwork, which itself is in contact with a live conductive part. The primary or basic function of residual current devices is to provide fault protection. However, where devices have an adequate sensitivity (i.e. units having operating residual currents not exceeding 30 mA), they provide the additional benefit of people (and livestock) protection to a user making direct contact with a live conductive part where other methods of protection failed. The operating characteristics given in this document are therefore based on requirements, which themselves are based on the information contained in IEC 60479-1 and IEC 60479-2. Residual curre
Scope: This document provides general minimum requirements, recommendations and information for the drafting of standards on residual current operated protective devices (hereinafter referred to as residual current devices, "RCDs"). It applies to any device providing residual current protection intended primarily for protection against electric shock hazard. NOTE 1 Residual current monitors (RCMs) according to IEC 62020, whose purpose is to monitor an electrical installation and not to provide protection, are not covered by this document and cannot be considered similar or equivalent to RCDs. NOTE 2 RCDs for DC supply system are under consideration. NOTE 3 For the relationship between this document and the RCD product standards, see Annex D. This document is primarily intended to be used as a reference for drafting product safety standard for devices identified as "RCD" or "residual current device" either for general use or incorporated or embedded in equipment. This document is also intended to be used as a reference for defining the design requirements and the applicable testing procedure for an RCD incorporated or embedded in an equipment. This basic safety publication is primarily intended for use by technical Committees in the preparation of standards in accordance with the principles laid down in IEC Guide 104 and lSO/lEC Guide 51. It is not intended for use by manufacturers or certification bodies. One of the responsibilities of a technical committee is, wherever applicable, to make use of basic safety publications in the preparation of its publications. The requirements, test methods or test conditions of this basic safety publication will not apply unless specifically referred to or included in the relevant publications.
Contents:
- FOREWORD
- INTRODUCTION
- Scope