Optical fibre cables – Part 1-2: Generic specification – Basic optical cable test procedures – General guidance
Introduction: IEC 60794-1-2:2013 comprised a detailed cross-reference table to the new document set, and general guidance was given in IEC 607941-20. These two specifications have been combined in this document, which allows for IEC 60794-1-20 to be withdrawn. A decision has been reached to reorganize the IEC 60794-1-2 set of test methods into single- subject documents. This will be a migration as the existing test methods are revised and as new test methods are promulgated, rather than a wholesale rewrite. Part of this migration is a decision to maintain the traditional letter-number classification and to use a numbering system which maintains connection to the existing numbering system. The new test method numbering format has been agreed, in line with IEC Secretariat guidelines, to help the cross-referencing from old to new and that will make the updating of the relevant sectional and product specifications easier. Cross-reference tables listing the new test method numbers and the previous test method numbers have been included (see Annex A, Table A.1 to Table A.8). The format agreed is as follows: IEC 60794-1-Xnn where X = 2nd digit of the old 2-digit reference; nn = incremental number (starting with old test method number). For example: IEC 60794-1-21 method E1 (tensile) becomes IEC 60794-1-101; IEC 60794-1-22 method F5 (water penetration) becomes IEC 60794-1-205; IEC 60794-1-23 method G7 (tube kinking) becomes IEC 60794-1-307; IEC 60794-1-24 method H2 (lightning) becomes IEC 60794-1-
Scope: This part of IEC 60794-1 applies to optical fibre cables for use with telecommunications equipment and devices employing similar techniques, and to cables having a combination of both optical fibres and electrical conductors. The prime objective of this document is to provide the end user with an overview about the content of different parts of the IEC 60794-1 series numbered -2X. Table 1 shows the different parts. An objective of this document is to define general requirements and methodology guidance applicable to all of the cable test methods of IEC 60794-1 (all parts). A second objective of this document is to provide the end user with an overview of the different test methods contained in the different parts of the IEC 60794-1 series, numbered -Xnn. Table 1 shows the different parts. Table 1 – Document overview Test methods IEC reference Previous compendium reference Test method category reference letter General guidance IEC 60794-1-2 IEC 60794-1-2 Mechanical IEC 60794-1-1nn IEC 60794-1-21:2015 Methods E Environmental IEC 60794-1-2nn IEC 60794-1-22:2017 Methods F Cable elements IEC 60794-1-3nn IEC 60794-1-23:2019 Methods G Electrical IEC 60794-1-4nn IEC 60794-1-24:2014 Methods H NOTE 1 The compendium reference specifications detailed in column 3 will continue in force until all of the test methods therein are revised into the single-subject documents using the new numbering scheme. NOTE 2 For existing test methods, "nn" is the test method number. For new test methods, "nn" is an incremental number following the last test method number for that test category. NOTE 3 Several numbers in the test method numbering sequence are missing. The reasons for these omissions are historical. To avoid confusion, the existing numbering sequence has been retained. These documents define test procedures to be used in establishing uniform requirements for the geometrical, transmission, material, mechanical, ageing (environmental exposure) and climatic properties of optical fibre cables, and electrical requirements where appropriate. Throughout the documents, the wording "optical cable" can also include optical fibre units, microduct fibre units, etc. The secondary objective o
Contents:
- FOREWORD
- INTRODUCTION
- Scope