IEC 60835-2-2-1994 PDF

IEC 60835-2-2-1994 PDF

Methods of measurement for equipment used in digital microwave transmission systems - Part 2: Measurements on terrestrial radio-relay systems - Section 2: Antenna

$100.88 $201.76 -50%
Product Code: IEC 60835-2-2
Stock In Stock
Edition: 1.0
Published: 05/1994
Number of Pages: 48
File Size: 1 file, 1 Byte

Available Options

Product Description

Methods of measurement for equipment used in digital microwave transmission systems - Part 2: Measurements on terrestrial radio-relay systems - Section 2: Antenna

Introduction: Antennas are key elements of radio-relay systems. A satisfactory fade margin for such systems is usually obtained by using high directivity, i.e. high-gain, antennas at both the transmitter and receiver terminals of a radio link. An antenna with a high directivity usually also has a narrow beam width main lobe which can provide a useful measure of protection against reflected rays. These reflected rays can lead to multipath fading. Rapid sidelobe suppression away from the main lobe is often a requirement at radio-relay system nodes to provide sufficient de-coupling between radio links which employ frequency use and small angular separation between the line-of-sight paths. Moreover, and especially for digital radio-relay systems, a high cross-polarization discrimination is necessary to provide sufficient decoupling between adjacent orthogonally polarized channels where the signal spectra overlap considerably, and between two orthogonally polarized co-frequency channels, i.e. using the same nominal carrier frequency. If the antenna under test is installed with a radome in normal operation on a radio link, all measurements should be performed with the radome fitted.

Scope: This section of IEC 835-2 gives methods of measurement of the electrical characteristics of antennas used in terrestrial radio-relay systems at frequencies above 1 GHz. The methods described are suitable for both line-of-sight and tropospheric scatter radio-relay systems using linear polarization. This section does not consider methods of measurement for passive repeaters or periscope antennas nor does it address systems where the antenna cannot be measured separately.

Contents:

  • FOREWORD
  • INTRODUCTION
  • 1 Scope
  • 2 Normative references
  • 4 Methods of measurement
  • 4.2 Antenna gain
  • 4.3 Radiation patterns
  • 4.5 Return loss

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 60835-2-2-1994 PDF

IEC 60835-2-2-1994 PDF

$100.88 $201.76