Methods of measurement for equipment used in digital microwave radio transmission systems - Part 3: Measurements on satellite earth stations - Section 10: Terminal equipment - TDMA traffic earth station
Introduction: In a TDMA (Time Division Multiple Access) satellite communication system, the reference earth station transmits the reference burst which provides a timing reference to the traffic (non-reference) earth stations. In many TDMA systems, the reference earth station monitors the operation of the traffic earth stations, and controls them in case of a burst plan change, etc. Usually, at least two reference earth stations are included in a TDMA system for redundancy purposes. A block diagram of typical TDMA terminal equipment for a traffic earth station is shown in figure 1. This section deals mainly with the method of measurement for the TDMA terminal used in traffic earth stations. It consists of PSK modulator/demodulator (PSK modem), Common TDMA Terminal Equipment (CTTE) and one or more Terrestrial Interface Mod- ules (TIM). The PSK modem interfaces with the earth station r.f. equipment at an inter- mediate frequency of typically 70 MHz or 140 MHz, and the TIE interfaces with the terrestrial digital circuits. The CTTE processes the transmit data from the TIE, produces transmit bursts, processes received bursts and sends recovered data to the TIE. It also controls the acquisition and synchronization functions. Special measuring equipment specific to the system, such as the reference burst generators, the burst negator, the burst mode bit error ratio measuring set, etc., may sometimes be required for measurement of the TDMA terminal equipment. They may be provided by the manufactur
Scope: This section deals with methods of measurement on Time Division Multiple Access (TDMA) terminal equipment. There are various type of TDMA systems which may differ, for instance, in the bit rate, the frame/burst format, and/or the acquisition and synchronization scheme. In this section, the methods of measurement are described as generally as possible so that they may be applicable to various TDMA terminal equipment used in many interna- tional and regional satellite systems.
Contents:
- FOREWORD
- INTRODUCTION
- 1 Scope
- 2 Normative references
- 3.1 Return loss
- 3.2 Level, frequency and spectrum of the modulator output signal
- 3.3 Carrier on-off ratio
- 3.4 Phase and amplitude balance
- 4.1 Level and shape of the output signal
- 4.2 Other parameters
- 5.1 General consideration
- 5.2 Modem BER performance
- 5.3 Overall system BER performance
- 6.1 General considerations
- 6.2 Clock frequency and acquisition time
- 6.3 Receive frame acquisition and synchronization
- 6.4 Transmit frame acquisition
- 6.5 Transmit frame synchronization
- 6.6 Synchronization characteristics with additive noise
- 7.1 General considerations
- 7.2 Reference station changeover test
- 7.3 Burst Time Plan and/or Channel Mapping Plan change test
- 7.4 Other monitor and control function tests, including service channels