IEC 60862-2-2012 PDF

IEC 60862-2-2012 PDF

Surface acoustic wave (SAW) filters of assessed quality-Part 2: Guidelines for the use

$239.59 $479.18 -50%
Product Code: IEC 60862-2
Stock In Stock
Edition: 3.0
Published: 05/2012
Number of Pages: 128
File Size: 1 file, 1 Byte

Available Options

Product Description

Surface acoustic wave (SAW) filters of assessed quality – Part 2: Guidelines for the use

Introduction: This standard has been compiled in response to a generally expressed desire on the part of both users and manufacturers for guidance on the use of SAW filters, so that the filters may be used to their best advantage. To this end, general and fundamental characteristics have been explained here. The features of these SAW filters are their small size, light weight, adjustment-free, high stability and high reliability. SAW filters add new features and applications to the field of crystal filters and ceramic filters. At the beginning, SAW filters meant transversal filters which have two interdigital transducers (IDT). Although SAW transversal filters have a relatively higher minimum insertion attenuation, they have excellent amplitude and phase characteristics. Extensive studies have been made to reduce minimum insertion attenuation, such as resonator filter configurations, unidirectional interdigital transducers (UDT), interdigitated interdigital transducers (IIDT). Nowadays, various kinds of SAW filters with low insertion attenuation are widely used in various applications and SAW filters are available in the gigahertz range.

Scope: This part of IEC 60862 gives practical guidance on the use of SAW filters which are used in telecommunications, measuring equipment, radar systems and consumer products. IEC 60862-1 should be referred to for general information, standard values and test conditions. SAW filters are now widely used in a variety of applications such as TV, satellite communications, optical fibre communications, mobile communications and so on. While these SAW filters have various specifications, many of them can be classified within a few fundamental categories. This part of IEC 60862 includes various kinds of filter configuration, of which the operating frequency range is from approximately 10 MHz to 3 GHz and the relative bandwidth is about 0,02 % to 50 % of the centre frequency. It is not the aim of this standard to explain theory, nor to attempt to cover all the eventualities which may arise in practical circumstances. This standard draws attention to some of the more fundamental questions, which should be considered by the user before he places an order for a SAW filter for a new application. Such a procedure will be the user's insurance against unsatisfactory performance. Standard specifications, given in IEC 60862 series, and national specifications or detail specifications issued by manufacturers, define the available combinations of nominal frequency, pass bandwidth, ripple, shape factor, terminating impedance, etc. These specifications are compiled to include a wide range of SAW filters with standardized performances. It cannot be over-emphasized that the user should, wherever possible, select his SAW filters from these specifications, when available, even if it may lead to making small modifications to his circuit to enable standard filters to be used. This applies particularly to the selection of the nominal frequency.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 60862-2-2012 PDF

IEC 60862-2-2012 PDF

$239.59 $479.18