Modular order for the development of mechanical structures for electrical and electronic equipment practices – Part 1: Generic standard
Introduction: There is a continuous trend towards higher functional integration and smaller electronic components and integrated circuits. At the same time, new manufacturing methods, automatic manufacturing and testing equipment, and Computer Aided Engineering (CAE) systems have created commercial advantages for their users. For users to take technical and economic advantage of these new components and technologies during planning, design, manufacturing, and testing, it is necessary for equipment practices to meet the following requirements (see IEC Guide 103): arrangement of products with a minimum loss of area and space; dimensional interchangeability of products, e.g. regarding overall dimensions, mounting dimensions (fixing holes, cut-out, etc.); dimensional compatibility and determination of interface dimensions of products which: are combined with other products, e.g. instruments, racks, panels and cabinets, etc.; are used in buildings that have been built in accordance with a modular system, e.g. column spacing, room height, door height, etc. An obstacle arises from the use of two systems of dimensioning (inch – metre) that are not compatible with each other. The use of an interface between both dimensioning systems represents one way around this obstacle. The recommendation is: to use only one dimensioning system and to use SI units. The dimensions given in 5.3 of this document have been taken from System l of IEC Guide 103 in consideration with other documents on dimensional coor
Scope: This part of IEC 60917 specifies the relationships between equipment practices and the modular order which are applicable to the main structural dimensions of electronic and electrical equipment mounted in various installations where dimensional interfaces have to be considered for mechanical compatibility. This document also established terms for parts and assemblies of mechanical structures for electrical and electronic equipment, to clarify the specific relations between equipment practices and modular order.
Contents:
- FOREWORD
- INTRODUCTION
- Scope