IEC 61000-6-3 (REDLINE + STANDARD)-2026 PDF

IEC 61000-6-3 (REDLINE + STANDARD)-2026 PDF

Electromagnetic compatibility (EMC) - Part 6-3: Generic standards - Emission standard for equipment in residential locations

$407.31 $814.61 -50%
Product Code: IEC 61000-6-3 (REDLINE + STANDARD)
Stock In Stock
Edition: 4.0
Published: 04/2026
Number of Pages: 148
File Size: 1 file, 5.6 MB

Available Options

Product Description

Electromagnetic compatibility (EMC) - Part 6-3: Generic standards - Emission standard for equipment in residential locations

Introduction: IEC 61000 is published in separate parts according to the following structure: Part 1: General General considerations (introduction, fundamental principles) Definitions, terminology Part 2: Environment Description of the environment Classification of the environment Compatibility levels Part 3: Limits Emission limits Immunity limits (insofar as they do not fall under the responsibility of the product committees) Part 4: Testing and measurement techniques Measurement techniques Testing techniques Part 5: Installation and mitigation guidelines Installation guidelines Mitigation methods and devices Part 6: Generic standards Part 9: Miscellaneous Each part is further subdivided into several parts published either as International Standards, technical reports or technical reports/specifications, some of which have already been. These are published as sections. Others will be published with the part number followed by a dash and a second number identifying the subdivision (example: IEC 61000-6-1).

Scope: This generic EMC emission standard is applicable only if no relevant dedicated product or product family EMC emission standard has been published. This part of IEC 61000 for emission requirements applies to electrical and electronic equipment intended for use at residential (see 3.1.21) locations. This part of IEC 61000 also applies to electrical and electronic equipment intended for use at other locations that do not fall within the scope of IEC 61000-6-8 or IEC 61000-6-4. The intention is that all equipment used in the residential, commercial and light-industrial environments locations are covered by IEC 61000-6-3 or IEC 61000-6-8. If there is any doubt the requirements in IEC 61000-6-3 apply. The conducted and radiated emission requirements in the frequency range up to 400 GHz are considered essential and have been selected to provide an adequate level of protection of radio reception in the defined electromagnetic environment. Equipment that have a radio function (3.1.20) are included in the scope of this document. However, the emission requirements in this document are not intended to be applicable to the intentional transmissions from these radio transmitters, their harmonics and their out of band emissions. Not all disturbance phenomena have been included for testing purposes but only those considered relevant for the equipment intended to operate within the locations included within this document. The emission requirements in this document are not intended to be applicable to the intentional transmissions and their harmonics from a radio transmitter as defined by the ITU. The objectives of this document are: a) to establish requirements that provide an adequate level of protection of radio reception in the frequency range 9 kHz to 400 GHz; b) to establish requirements that provide an adequate level of protection against conducted and radiated electromagnetic disturbances emitted by equipment in the scope of this document; c) to support the reproducibility of measurement and the repeatability of results. NOTE 1 Safety considerations are not covered by this document. NOTE 2 1 In special cases, situations will arise where the levels specified in this docume

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 61000-6-3 (REDLINE + STANDARD)-2026 PDF

IEC 61000-6-3 (REDLINE + STANDARD)-2026 PDF

$407.31 $814.61